aaflyer

My Feedback: (121)

Just installed AR9000. Binding was normal at home. Got to the field set everything up. Everything worked normally. Fueled up. Powered up again and nothing. Servos went their correct position. Binding light was flashing. Attempted to bind again at the field without sucess. Got home repowered everything up. Everything was back to normal??. I know these are vague symtoms. But anyone with any generic ideas what might be going on??

Al

dsnyder

Were the lights flashing slowly or fast? If slowly, that could be an indication of a power problem. If fast, it is being put into bind mode somehow.