GP Easy Sport 40: engine thrust
06-12-2003 | 11:12 AM
#1
Thread Starter
Member
Joined: May 2003
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
From: Kessel, BELGIUM
GP Easy Sport 40: engine thrust
I'm currently building this kit, and I'm mounting an OS .46FX engine in it.
Now, the firewall doesn't seem to have any right thrust build-in, so, is this not required for this plane, or would I benefit from giving it a slight degree of right thrust anyway ?
Now, the firewall doesn't seem to have any right thrust build-in, so, is this not required for this plane, or would I benefit from giving it a slight degree of right thrust anyway ?
06-12-2003 | 12:40 PM
#2
Senior Member
My Feedback: (4)
GP Easy Sport 40: engine thrust
It's not critical, but it wouldn't hurt if you want to do it. The easiest way is to build it as per the instructions, then, once it's finished, add 1 or 2 washers to each of the left engine mount screws between the mount and the firewall.
06-12-2003 | 02:06 PM
#3
Thread Starter
Member
Joined: May 2003
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
From: Kessel, BELGIUM
GP Easy Sport 40: engine thrust
Thanks MinnFlyer!
Do you have a picture for everything ? Or do you just make them up on request ? Great going!
I already build to fuselage & firewall as per the plans, so the washer thingie is the only way I could go... I guess a little experimenting wouldn't hurt right?
Do you have a picture for everything ? Or do you just make them up on request ? Great going!
I already build to fuselage & firewall as per the plans, so the washer thingie is the only way I could go... I guess a little experimenting wouldn't hurt right?
