RCU Forums - View Profile: FUTABA-RC

Go Back  RCU Forums >
Reload this Page >

FUTABA-RC's Profile



About Me

  • About FUTABA-RC
    I am a member of Team Futaba and provide support on a volunteer basis to help people get the most out of
    their Futaba products.
  • Signature
    Bill M
    Team Futaba Product Support


Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 11-03-2023 08:52 PM
  • Join Date: 10-23-2017


Showing Friends 1 to 2 of 2

Visitor Messages

Showing Visitor Messages 1 to 5 of 5
  1. 07-28-2023 08:59 PM
    Hello FUTABA-RC!! how can i contact you, email? WhatsApp? Whatever!!!! I'm new to the forums and I don't know how to navigate through them!!! I have for the first time a futaba transmitter and its receiver! and I would like to tell you a few things to know your opinion!! It would really be a huge help to me!! Greetings
  2. 03-29-2022 04:32 AM
    Where can I find out about turning on Dual Rates on a Futaba T18SZ?

    I've followed the manual but can only get 1 and 4 of the 6 D/R into the ON Status. 2,3,5,6 only toggle between INH and OFF.

    Either there's something wrong with the Tx or with my understanding of the manual. I'm assuming the latter! ;-)

    There's still the matter of SETTING D/R once they're ON but I *think* I get that part.

    Sorry if I'm asking in the wrong place!


    Rupert ;-)
  3. 09-01-2020 03:09 PM
    I have a Futaba 14 MZ which I am replacing with Futaba 16 SZ which has new added functions I need plus the 14 by electronic standards is very old but over its lifetime has been very reliable .

    Does anyone have info on how to transfer data from one tranny , the 14 MZ. to the other 16 SZ as manually re-entering individual aircraft data and finessing thru test flights would be quite a chore. I cannot find any info on the Futaba web site for this tranny combination data transfer

    would appreciate any advice or direction to accomplish same.
    Dick G.
    08-19-2018 08:01 PM
    Sorry - just saw this. What servos are you using? When you say the RX starts flashing what color and how fast is it flashing?
  5. 08-08-2018 05:44 PM
    I have a new R2008SB receiver and in the process of centering up two aileron servos I ran into a problem. I am using a standard "Y" harness and when plugging in one servo it works fine but when I plug in the second servo into the other side of the Y harness the receiver begins to blink and both servos do not function. Do I have a defective receiver or am I doing something wrong?

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.