MVVS engines
03-25-2006 | 09:28 AM
#3
Junior Member
Joined: Feb 2005
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
From: Oakville/On, ON, CANADA
RE: MVVS engines
Hello Pe, with my new 35 cc MVVS engine I have a question about the anodized motor mount. I s this motor mount preferable to the bar mount at engine sides. Would bar mount reduce or maintain a lower vibration/swing of the engine and would the barmounts along the sides of the engine not be stronger? Thanks for your support.mrpip
11-30-2006 | 01:14 PM
#4
Junior Member
Joined: Nov 2006
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
From: shikshinny, PA
RE: MVVS engines
? mvvs 10cc 12x8 prop 15% nitro just before it comes on the pipe it will back fire thrugh the carb and go in an oseslarion and stop runing then i have to back the needle out and start over again i think it is under proped and to much nitro did i answer my own ? .
