expo

My Feedback: (20)

I recently bought a Morris Spinsation flying wing kit from a club member and it's going to be my first build. Has anyone heard about, seen, built, flew, or crashed one of these?? I've got an extra .46 and a .40 I can put on this.

I'm looking for any advice at all on this plane.

JWilliams

My Feedback: (6)

Are you sure that is not called the Spinsation?
Jeff W.

expo

My Feedback: (20)

Jwilliams--I stand corrected and edited my post--

You must have heard of it???

rcflyerdave

I am on my second one and my buddy is building his second one.We have had one since we went to Lexengton,Ky to see Tom Stryker test fly the prototype that wasnt named then.You will love it.It is not your typical airplane.It will do manuevers no other plane will do.
After you get your first few test flights in and blistering roll rates and flatttttt spins in,take it high and while wide open cram sticks in odd positions and see what it does and name the man. and try another stick position and watch.My favorite position is to push both sticks all forward and to center and slowly move right stick to right to chane tricks.It does a dead chicken flowing around like you wouldnt believe.I cant understand why I never see hardly any of these at flyins.It will make you appear like a much wilder flyer than you are.Also it flys slow. Good luck you wont be disapointed.
Dave

expo

My Feedback: (20)

Dave,
Excellent information--Thank you.

If I may pick your brain some more, I have a couple of spare engines, OS.40LA and a OS MAX .46. Any recommendations as to which one to mount?

Would S3004 Futaba servos be OK for all the control surfaces?

Also, since this is my first build, do you have any suggestions when I assemble the skeleton?


Thanx, Expo

rcflyerdave

I've had os sf46 with 11-4 APCs onall my profiles with great success and real good pipe is Tower 12$ PIPE.jUST FOLLOW DIRECTIONS.nOT THE EASIEST BUT NOT HARD EITHER.
dAVE