saito 72 problem
#1
Member
Thread Starter
Join Date: Nov 2002
Location: Phoenix, AZ
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
saito 72 problem
I had a saito 72 I put on a morris top cap. I reversed the carb to accommodate the throttle pushrod. On the forth flight I had a dead stick landing. When I got to the plane the carborator mount had BROKE off the rear cover. All the screws were tight. Has anybody else had this problem?
The engine ran fine when I hade it on another plane with the carb the right way.
The engine ran fine when I hade it on another plane with the carb the right way.
#4
Senior Member
My Feedback: (1)
Join Date: Dec 2001
Location: Bloomington,
IL
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
saito 72 problem
Did it look like the pics in this thread?
Saito Carb Seperation
Happend to me too. Replaced the backplate, no problems since.
Karll
Saito Carb Seperation
Happend to me too. Replaced the backplate, no problems since.
Karll
#5
Member
Thread Starter
Join Date: Nov 2002
Location: Phoenix, AZ
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
saito 72 problem
That is exactly what happened! Thanks for the link.
It does not look like there is anything you can do to prevent this from happening. I have the new back plate on order.
It does not look like there is anything you can do to prevent this from happening. I have the new back plate on order.