Anyone used Elmers Probond for installing Robart hinge points?

rbeck

Yes.......

Rbeck
It works great. Oil up the hindge joint in case a little leaks
in to it.
I use it on foam wings and it really holds great.

Syd

I've been using RC56 for the robarts since it was suggested to me at a IMAC contest. They won't come loose from vibration as they will with a hard glue. 30% 300 and 1/3 scale Cap with this glue, no problems. Also if any gets in the pivot point it will roll out with moving control surface back and forth.

Probond poly, works great with hinge points. It fills any voids and on built up surfaces, it forms a nice bead around the inner exposed point.