Powerbox sensor switch
08-01-2008 | 04:06 PM
#1
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
From: essex, UNITED KINGDOM
Powerbox sensor switch
Hi
I am currently building a Composite ARF Extra DA 50 MTW canisters etc but my question is to do with the radio set up. I am using two JR 8511 and 3 JR 8911 servos i wanted to use a Powerbox Sensor switch running two LiPo' of about 2amps each battery. Is the powerbox sensor switch ok to use in this setup or should i be considering a powerbox professional for example? I want to keep the weight down but am unsure if the sensor switch alone is the way to go???
I am currently building a Composite ARF Extra DA 50 MTW canisters etc but my question is to do with the radio set up. I am using two JR 8511 and 3 JR 8911 servos i wanted to use a Powerbox Sensor switch running two LiPo' of about 2amps each battery. Is the powerbox sensor switch ok to use in this setup or should i be considering a powerbox professional for example? I want to keep the weight down but am unsure if the sensor switch alone is the way to go???
11-10-2008 | 05:42 AM
#2
Senior Member
Joined: Jun 2002
Posts: 819
Likes: 0
Received 0 Likes
on
0 Posts
From: Carrollton,
TX
RE: Powerbox sensor switch
Frazerrees,
When you hook up your PB sensor what is the voltage readout at the receiver. I've been using one for a while now and its great on 50cc planes.
jds
When you hook up your PB sensor what is the voltage readout at the receiver. I've been using one for a while now and its great on 50cc planes.
jds
