I have recently purchased a Hyper 7 PBS PCR, I have noticed throughout the posts I have searched, that the steering servo on this buggy is not exactly the best. Does anyone have any suggestions for a good servo? If this has been asked before, please excuse me. This is my first buggy and I am kinda new to the r/c thing.(started in dec. 04 with a tmaxx). Any help would be greatly appreciated.

I have the same buggy and run the Airtronics 94358 in mine. Tons of torque, 200oz @ 6.0volts. No doubt that it moves the wheels around, but I find I do pay a penalty with decreased battery run time. You may want to get a slightly faster servo than this one, with still a decent amount of torque. After all, I don't need this much torque, but i want this much torque.

t/y puffer, any other ideas out there?

JR z650m - it's not as expensive as an Airtronics, but it's is strong enough and has metal gears.

You could probably get a Revo servo cheap off ebay.. 80oz of tourque for around $10. Not the best choice but it has economy going for it.

you could go for a cheaper servo Hitec 645mg

At 6V
Speed 0.20 sec/60º
Torque 9.6kg/cm
Metal gears
Ballraced

or a KO Propo 2344


At 6V
Speed 0.13 sec/60º
Torque 13.0kg/cm
Metal gears
Ballraced

Thank you all, I will check these out.

Ahh yes get the hitec 645Mg

towerhobbies.com and servocity.com has the best prices online

I also run a hi tech 645 ultra torque on my PBS

mike

u always got pleanty of of torque Mike



Neil

Run a KO 2344 in mine loads of torque and very fast too.

Downside = expensive

Thank you all, after consideration and talking with a few others in my r/c club, I got the hitec hs-5945mg, digital ultra torque. speed .013 secand 180.53 oz torque.

I am in the same spot as you, but I think I am going with the Airtronics 94358z! And I will probably will pick up a Traxxas RX Battery pack off ebay!

Hey guys, installed the servo and gave it a run. Thiss servo is UNREAL!!!! What a difference, I think I will get the high speed one for my throttle servo.