Community
Search
Notices
RC 1/8th Scale Buggies Discuss the ever popular category of 1/8th scale rc buggies in this forum!

Steering Problem

Thread Tools
 
Search this Thread
 
Old 05-04-2009 | 06:15 PM
  #1  
Thread Starter
Member
 
Joined: Feb 2006
Posts: 71
Likes: 0
Received 0 Likes on 0 Posts
From: Florham Park, NJ
Default Steering Problem

Hey, i have a Sportwerks Mayhem, and i have a problem with the steering. When i turn it to the right, it goes back to neutral, and the car can go i a straight line, but when i turn it to the left, it doesn't turn back to neutral, and turns a little bit to the left, so i won't go in a straight line. I put a new HT servo in it, but i still have the same problem. Please help me with this. Thank You.
Old 05-04-2009 | 07:00 PM
  #2  
Member
 
Joined: Dec 2008
Posts: 66
Likes: 0
Received 0 Likes on 0 Posts
From: hayward, CA
Default RE: Steering Problem

adj the trim on your transmitter.first though take the horn off the servo turn your radio and reciver point your wheels as close to center as you can then put the horn back on adj the trim with your transmitter.make sure the horn is not slipping on the servo differnt servos differnt splines.
Old 05-04-2009 | 08:25 PM
  #3  
Thread Starter
Member
 
Joined: Feb 2006
Posts: 71
Likes: 0
Received 0 Likes on 0 Posts
From: Florham Park, NJ
Default RE: Steering Problem

I tried adjusting the trim and i am sure nothing is slipping. Is there anything else causing this.
Old 05-04-2009 | 09:00 PM
  #4  
Senior Member
 
Joined: Jan 2008
Posts: 464
Likes: 0
Received 1 Like on 1 Post
From: Red Oak, TX
Default RE: Steering Problem

It could be your rx! Can you check your servos with a another rx like one of your buddies?
Old 05-05-2009 | 03:09 AM
  #5  
tommygun32's Avatar
Senior Member
 
Joined: Mar 2008
Posts: 4,857
Likes: 0
Received 0 Likes on 0 Posts
From: San Diego but living in Dubai, UNITED ARAB EMIRATE
Default RE: Steering Problem

Another idea. Make sure your servo saver isn't too tight. Also check that the bearings in your servo saver aren't shot. Double check the range of travel of your wheels and turnbuckles with the servo disconnected and make sure nothing is impeeding that movement. Good luck.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.