Hi does anyone here know if its possible to convert my pull start 16nt engine to a rotary start using a drill to start up the engine?

sort off need to know before tomorrow because i have to visit my lhs by then.

thanks

Try checking into the hgi yank eliminator, the only scary thing is the rear engine bearing is left exposed

you might if the pullstart uses a one way with a hex shaped out side becaues you could use a ratchet socket with a small adapter to attach it to the drill.

ok thanks...

how much would both of them cost

i think im gonna try using the second idea as its free and im cheap. Ive been told thoe it would be easy to strip the one way bearing.

How could i attach the one way bearing to a drill with out damaging it when i use it.

thanks for your help i know what i am going to do and how im going to do it

Thanks

go to a hard ware store and fine the correct size socket and ask about and adapter. they are generally about 3/4 of and inch long, one end is mad for a 1/4 inch drive socket and the other end is hex shaped so it fits the drill easily. for both you are talking $5-6 dollars tops

ok kewl.. all i need is the adapter i found the socket but i couldnt get it to fit in my drill[:@]


thanks ill get a adapter tomorrow