tmaxx tranny problem
#1
Thread Starter
Junior Member
My Feedback: (2)
Joined: Mar 2002
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
From: cavespring ,
GA
my t maxx only has second gear all my gears look good im not really sure how to adjust the shift point i think that might help any suggestions please let me know by email thanks chuck
#4

My Feedback: (38)
Take the little plug off the tranny, spin the gears until you see a slot in the white gear inside. Then hold the spur and spin the little shaft that sticks out one end of the trans until you see a setscrew, now, on mine there is two screws, one that goes directly toward the shaft you are spinning, the other goes beside it, that is the one you want. tighten it up a little at a time to see what happens. does that make any sense?
#6

My Feedback: (38)
The problem is it instantly shifts, before you know it, if you do as I said youll fine tune the shift point to where the engine revs up a bit before it happens. One of the screws will be in all the way, dont loosen that one, one should turn in farther, do that one



