just put my integy 55t in my tt-01 , it drifts tottally different as the cars speed is reduced ,its so much more controlable , using sushi drift tyres , also found when i had the car stripped down to put the motor in and to apply grease to gears my tamiya propshaft pins had slid to one side leaving a very short pin on both ends ,(i had had a slight vibration when using the car the last two times i have used it ) have tapped them back in place , has anyone else had the same problem , is there a fix anyone knows about , i was thinking supergluing them into the propshaft, sorry about pic best i could do ( not my prop ,just to show the pin i mean)

yes super glue it just don't go overboard with the super glue

will have to check my prop havent in a while[X(]
ditto on that 55 mark,just geared mine 25/55 wanna see what speed it will get running a checkpiont money motor and new 3300 packs

im running standard gearing and 3700mah nimh packs , everything went ok on the first outing with the 55t in , esc stayed cold motor was warm


quite happy with it , gonna try and go out with a fully charged pack an drift till its dead , see how long run time i get and see if the motor doesnt get too hot [sm=thumbs_up.gif]

HOw much was the integy and were did you get it from ,

i plan on trying it!

i got it here http://www.lstshop.co.uk/catalog/pro...cb73d22cf31805



boltomn england , they only do a 35t now though , i am goin to get one and put it in my tt01 and put my 55t back in my buggy , as the 35t revs slightly faster

You say standard gearing mark,you mean 19t pinion?surely it wont mesh with a 55t spur?

the spur and pinion gears i am using are the standard ones that come with the car , untill i strip the gear cover off and count the teeth on each im not sure how many each gear has

how slow does it go now? lol like 15 mph?

Slow doesnt matter for Dift, Unless ur using rubber tires!,

thx for the Link!

speed = racing , torque = drifting

i have pm'd you a closer link

ThnX[8D]

ahh my bad mark i thought u ment you were using the 55t spur on a standard 19t pinion which wont work lol
yeh agree the standard gearing 19/61 on a lower turn motor is best combo for drifting been using 23/58 for a while think its better for abs myslef less spin (lol i know less spin lol)

as for slow remark if i gear mine 28/55 she GPSes 31mph on a elecy that fast enough for ya [8D]