fan clamps for motor
#1
Senior Member
Thread Starter
Join Date: Dec 2005
Location: Oshkosh,
WI
Posts: 1,826
Likes: 0
Received 0 Likes
on
0 Posts
fan clamps for motor
I am looking for a fan clamp for my upcoming brushless e-savage. My questions are the following.
1. Which one would be better?
2. Would they work in a extra slot on my reveiver? (would thet get enough voltage)
http://www3.towerhobbies.com/cgi-bin...?&I=LXRXY6&P=7
http://www3.towerhobbies.com/cgi-bin...?&I=LXNPF9&P=7
I am kind of leaning towards th integy one because the motor will be kinda long. And that covers more area.
Thanks for all of the help.
1. Which one would be better?
2. Would they work in a extra slot on my reveiver? (would thet get enough voltage)
http://www3.towerhobbies.com/cgi-bin...?&I=LXRXY6&P=7
http://www3.towerhobbies.com/cgi-bin...?&I=LXNPF9&P=7
I am kind of leaning towards th integy one because the motor will be kinda long. And that covers more area.
Thanks for all of the help.
#2
Senior Member
Thread Starter
Join Date: Dec 2005
Location: Oshkosh,
WI
Posts: 1,826
Likes: 0
Received 0 Likes
on
0 Posts
RE: fan clamps for motor
I just ralized how much that LRP fan is![X(] Way too much! I guess I will get a integy one. But I still have this question. How much voltage does a third channel on a receiver put out? If it happens to depend on the voltage I will be running on it will be 4s lipo, about 16.8v.
Thanks for all of the help
Thanks for all of the help