Just installed a new HD in my computer. Installed a Maxtor 40Gig 7200 RPM to replace a 20G 5400RPM. I used the Maxtor utility to copy all the data from the old HD to the new one then made the new one the master. Everything works fine except RF G2... After the Loading G2 screen I get the error KEError 92994. Says to talk to tech support... Anyone seen this problem?

update your drivers to the lastest ones avail for your sound and video card manufacures.......

... or uninstall and re-install G2. It's using a number of copy-protection schemes, probably, on of them just kicked in.

I reinstalled and everything is fine. Just wondered if I had to go through all that as I upgraded from RF to Dlux to G2 etc...

my G2 serial number keeps getting erased I dont get it. all of the add-on;s are fine