G2 Pros,
I am using G2 and I am quite happy.
Also downloaded the Morrisknife (thanks Bill however, when I click on relaod, the new scheme won't show up in the preview.
Is this normal or do I do something wrong here???

Regards
Rainer

Click the plane that its based off of. And then click
the arrow. then you will see the rest of the planes
in that file.
good luck
Jeff

You will also have to restart G2 if you were in it when you downloaded and installed the new scheme.

Thanks
Mike Badger
www.Aero3D.net

I think you are asking about the little about 1" x 1" picture of the plane when selecting the aircraft? Mine only shows the original scheme/plane as well.

Yes,
the small picture is what I was referring to.
I guess it won't change - well not too bad. I just thought I must have done something wrong!
Thanks for your advice!
Regards
Rainer

I was confused like that when I downloaded the SIG Sukhoi scheme. It didn't show up until I reloaded the software.

Sorry, what do you mean by confused?
Does the new plane show up in the plane selection menue (the small 1" x 1") or not?
Like GooberVA stated - it doesn't show in the preview, however, the plane loads ok.
Rainer

No the picture of the airplane will not change schemes its only there to show you what plane your choosing.

Thanks
Mike Badger
www.Aero3D.net