Is it possible to do mixing with the G2 Interlink controller ?
If so...could someone please tell me how to set this up, I would like to play around with flapperons on the Cap 232.

Thanks
Jason E Lepper

Make a copy of the Cap 232 and then edit it as follows:

In servos, set right aileron to channel 6

Then load the copied one in G2.

Go to edit radio:
On channel 1 : left aileron,
check input 6 checkbox and enter from 100 to -100 and set when Switch 2 on

On channel 6 : right aileron ,
check input 1 checkbox and enter -100 to 100
check input 6 checkbox and enter -100 to 100 and set when Switch 2 on

You will now have flapperons/spoilerons controlled by the right hand switch and the turning knob thing

Make sure your low rates and exponential are the same for Channel 1 and Channel 6

You can also mix in some elevator into channel 2 from input 6 when switch 2 is on if you like (say from -20 to 20 or something along those lines)