flaperons on G3
#1
Senior Member
Thread Starter
Join Date: Oct 2005
Location: St. Louis,
MO
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
flaperons on G3
does anyone know if you can program something on the G3 interlink radio to where both ailerons move as flaperons by one of the switches?? The Yak54 harriers MUCH better with the ailerons up about 10 to 12%, but I can only figure out how to make them like that all the time. As you can guess, it doesnt fly well inverted when its set up like that
any help would be great!
Thanks!
any help would be great!
Thanks!
#2
Senior Member
Join Date: Nov 2004
Location: Corvallis,
OR
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
RE: flaperons on G3
Try this:
http://h1.ripway.com/jaafit/RFG3/Flaperons.plnG3
Here's what I did. I changed the right aileron servo to get input from channel 9 instead of 1. Then I added inputs to channel 9 so that it mixed channels 1 and 8, 8 being the 3-pos switch. Then I added a channel 8 mix to channel 1 for the left servo. The results can be seen in this file if you load the aircraft editor and expand the Software Radio section.
http://h1.ripway.com/jaafit/RFG3/Flaperons.plnG3
Here's what I did. I changed the right aileron servo to get input from channel 9 instead of 1. Then I added inputs to channel 9 so that it mixed channels 1 and 8, 8 being the 3-pos switch. Then I added a channel 8 mix to channel 1 for the left servo. The results can be seen in this file if you load the aircraft editor and expand the Software Radio section.