hello everyone! i recently bought a trex 250 se.. i have a futaba 8fg and a r6106 reciever to go along with it...binding the reciever with the transmitter was not a problem....the problem that i am having is this:

the model is setup as stated: helicopter, hr3, 7ch

now when i got to setup my servos only one servo moves...i put each servo in the correct channels but only one servo moves, and thats the one in channel 6....channel 4 is for rudder and that works fine....but my pitch. aileron, and elevator servos do not move in sync, or at all for that matter....

am i doing something wrong? did i miss a step in the setup? or is this a faulty reciever?<br type="_moz" />

you have to go to the SWASH mix program.

Jim

thanks jim

but let me be specific im a SUPER NOOB!!! lol

i might need a lil more explanation

what exactly do i do once im in the swash mix setting?

ok....i just hooked my 8ch receiver to my 250 and everything is working fine....does this mean the 6ch receiver is faulty?

You have to switch a setting on your transmitter for the other receivers. You are now in Multi-ch mode. You need to switch it to 7-ch mode. Check your manual.

nope it wasnt that i already knew that part. i already sent the reciever to back to heliproz.com. the customer service rep larry tested it out, and said it was faulty. i recieve my new one today. soo i guess i was doing everything right. it was just a faulty reciever by futaba. sales rep said he's been working with futaba products for over 20yrs and this was the first faulty product he has seen!