ESKY Lama V3 Takeoff Issue
10-01-2020, 10:03 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2020
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
ESKY Lama V3 Takeoff Issue
Okay so,
I have just repaired my lama v3 after a few years of it sitting in my attic. I have managed to replace all the broken parts and have got it to the point of 95% completed.
I have all the parts back on, it connects to the remote and calibrates fine but then as I apply the throttle once it has enough power to lift it automatically tilts to the left on its own (like im holding the right stick on the remote to the left). I have checked the trim on the remote and it is centered and no other trims have been touched. Its to the point that iv rebuilt it multiple times just to check iv reconnected everything properly but now I'm just stumped for ideas.
Any help is appreciated.
I have just repaired my lama v3 after a few years of it sitting in my attic. I have managed to replace all the broken parts and have got it to the point of 95% completed.
I have all the parts back on, it connects to the remote and calibrates fine but then as I apply the throttle once it has enough power to lift it automatically tilts to the left on its own (like im holding the right stick on the remote to the left). I have checked the trim on the remote and it is centered and no other trims have been touched. Its to the point that iv rebuilt it multiple times just to check iv reconnected everything properly but now I'm just stumped for ideas.
Any help is appreciated.
