Walkera Dragonfly 4 lift problem
#1
Junior Member
Thread Starter
Join Date: May 2005
Location: , QC, CANADA
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Walkera Dragonfly 4 lift problem
Hi , first let me say you have a great site!
I'll do my best since my english is not the best!
Just got my dragonfly 4 last week and ran into series of problem.
I fix most of my problem except for one. After fixing the shaking problem
and finally found a way to do the trimming, I'm trying to lift off.
Here's my problem, when It does lift, it goes on his right side.
Like if someone was pulling a rope on the right side!
Anyone know what could cause this?
I'll do my best since my english is not the best!
Just got my dragonfly 4 last week and ran into series of problem.
I fix most of my problem except for one. After fixing the shaking problem
and finally found a way to do the trimming, I'm trying to lift off.
Here's my problem, when It does lift, it goes on his right side.
Like if someone was pulling a rope on the right side!
Anyone know what could cause this?
#2
Junior Member
Join Date: Apr 2005
Location: Jonesboro, GA
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
RE: Walkera Dragonfly 4 lift problem
Black Tracking is my quess. Still new myself but if the blades are way off then it will spin off in one direction.
Also when you turn on the controller does the unit servos center 90 degrees?
Also when you turn on the controller does the unit servos center 90 degrees?