Hi,
What functions are controlled on a helicopter that requires more than 5 channels?

Channel 1 - Cyclic
Channel 2 - Cyclic
Channel 3 - Tail Rotor
Channel 4/5 - Collective/Throttle
Channel 6 - ?
Channel 7 - ?
Channel 8 - ?
Channel 9 - ?

Thanks,
Glenn

I think u use other channels for stuff like

Head Holding on/off
Gyro gain
Throttle Governor on/off

Well thats wot i understand but im sure someone else will enlighten u better

On mine I have:

throttle
aileron
elevator
rudder
gear (governor on/off)
pitch
aux2 (gyro gain)
aux3 (head speed switch for gov)
aux 4 ( battery checker)
Bat (battery)

I can't get back into my receiver cos it's wrapped in foam and securely tie-wrapped so these were just from the top of my head. They are probably in the wrong order or have some mixed up.

James

i recommend a min. of 6ch... better get 8ch and you will be set if you want to use a governor

on the 9z it's the first slot is DSC ( direct servo control) then,
ch 1 ail (cyclic)
ch 2 elev (cyclic)
ch 3 throttle
ch 4 Rudder (gyro)
ch 5 gyro gain (HH on/off)
ch 6 pitch (collective)
aux 1 govenor Throttle
aux 2 govenor switch (on/off)
ch 9 batt monitor or anything you want (extra Batt and switch)?