Quick 60 Pro assembly...Servo's??
05-11-2003 | 08:14 PM
#1
Thread Starter
Member
My Feedback: (2)
Joined: Jan 2003
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
From: Boise,
ID
Quick 60 Pro assembly...Servo's??
I just got a Quick 60 Pro Carbon. I purchased this used from a guy via the net. It came shipped to me fully assembled w/out any electronics. My question is this.
Do I have to take the side frame apart to add the tail servo? The manual for this bird is not the best. It shows pictures of the servos being mounted with the side frames apart during initial assembly. However it does not indicate if this is necessary. I really want to start adding all of the finishing caps and checking all the bolts for locktight, but at the present time I don't have any servo's. Am I better off to wait for the servo's, or can I check everything, add locktight etc, and mount the servo's later??
Any advise is appreciated.
Do I have to take the side frame apart to add the tail servo? The manual for this bird is not the best. It shows pictures of the servos being mounted with the side frames apart during initial assembly. However it does not indicate if this is necessary. I really want to start adding all of the finishing caps and checking all the bolts for locktight, but at the present time I don't have any servo's. Am I better off to wait for the servo's, or can I check everything, add locktight etc, and mount the servo's later??
Any advise is appreciated.
