I bought the 2 channel Unilight controller from dreamworks with four LED's. Can't get it to power up. Hopefully missing something obvious? I plug power in, plug it into rx... assign a three position switch... nothing. Did the 10 second system reset while powering up the rx... nothing. Do I do this without the power to it? Shouldn't something fire on the board (small LED indicators) when I supply power or RX signal? I increased ATV's to 110 to see if it was missing... nothing.

love some help!

It's hard to diagnose without seeing exactly what you're doing so can only ask the obvious questions.

Have you plugged a servo into the receiver instead of the controller to check that the channel is working correctly?

I assume you have power to both the RX and the controller? And I assume that both are fully charged?

yes to all.... ;-).