Some time ago I thought I saw a thread where some meter was put on the servo line to assure clean operation of the attached surface. I cannot find the thread and wish to get that particular tool.

TIA

[link=http://www.horizonhobby.com/Shop/ByCategory/Product/Default.aspx?ProdID=HAN172]Hanger 9 servo meter[/link]

Heck, just wire up any amp meter in series with the servo of concern.

Mark, until you hold one of these jewels in your hand......... I have two of them! While you can do it with a volt meter, I just plug this in between my switch and everything else during setup and it's a no brainer to just look at it and go. Nothing to turn on and off, switch from volts to amps on it. I'm telling you this is a heck of a buy!

Thanks! I was starting to wonder if I had dreamed it!