MGT-Removing Reverse
#1
Senior Member
Thread Starter
Join Date: Jan 2004
Location: Abingdon,
MD
Posts: 6,382
Likes: 0
Received 0 Likes
on
0 Posts
MGT-Removing Reverse
If I were to remove the reverse in my MGT to make it a little lighter, What do I need to take out? And I think I need to buy something for it too?
Thanks.
Thanks.
#3
Senior Member
My Feedback: (10)
Join Date: Mar 2004
Posts: 1,813
Likes: 0
Received 0 Likes
on
0 Posts
RE: MGT-Removing Reverse
heres the FOC you need
http://www2.towerhobbies.com/cgi-bin...?&I=LXFVB7&P=7
then you would take out
-gears
- shifting fork
- servo
http://www2.towerhobbies.com/cgi-bin...?&I=LXFVB7&P=7
then you would take out
-gears
- shifting fork
- servo
#5
Senior Member
Join Date: Mar 2004
Location: On the snow,
QC, CANADA
Posts: 746
Likes: 0
Received 0 Likes
on
0 Posts
RE: MGT-Removing Reverse
Just a little thing, when you'll install the FOC, don't panic if you're not able to close the transmission case tight, becaus on the manual they give with the FOC, when it's time to install the gear on the output shaft, the picture not indicate the proper way to install the gear over the pin. To the place of slide the gear from the left side thru the gear, you must slide it from teh right side of the shaft.
Maybe you don't understand right now but when you'll have the picture in front of you, you'll understand.
Excuse my english,. i'am french from Québec, Canada.
Good luck
Maybe you don't understand right now but when you'll have the picture in front of you, you'll understand.
Excuse my english,. i'am french from Québec, Canada.
Good luck