Throttle in reverse?
02-12-2005 | 07:07 PM
#1
Thread Starter
Member
Joined: Jan 2005
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
From: Watertown, TN
Throttle in reverse?
Hey people!
As you can tell I'm a newbie so this may be a stupid question, Have a Hitec Tx and had to buy a new hitec reciever. After gettting everything together the steering worked fine but the throttle wide open! Tried turning off & on a few times to see if that would help. No go. The servos are futaba. Cant figure out. Any suggestions would be greatly appreciated
Thankx
P.S. This is on a RC-10Gt if that helps.
As you can tell I'm a newbie so this may be a stupid question, Have a Hitec Tx and had to buy a new hitec reciever. After gettting everything together the steering worked fine but the throttle wide open! Tried turning off & on a few times to see if that would help. No go. The servos are futaba. Cant figure out. Any suggestions would be greatly appreciated
Thankx
P.S. This is on a RC-10Gt if that helps.
02-12-2005 | 08:17 PM
#4
Thread Starter
Member
Joined: Jan 2005
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
From: Watertown, TN
RE: Throttle in reverse?
Thankx for the ideas but I found a lttle switch on the Tx that was set to normal, Switched to reverse and all is good! Is it a positive & negative thing when you use different brand servos or is it just with futaba Tx's & Rx's? that it acts like this. As I said I'm a newb to nitros so I will probably ask alot of stupid questions for a awile till I get a little bit more knowledgable, so bear with me
Thankx Again
Thankx Again
