Elevator servo recomendations?
05-26-2004 | 11:40 AM
#1
Thread Starter
Senior Member
My Feedback: (12)
Joined: Dec 2003
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
From: Rockledge,
FL
Elevator servo recomendations?
What elevator servo is good for a 60 size plane? I don't want to over kill it but I don't want to not have enough either. How much torque I guess is what I'mm asking.
thanks, Tom
thanks, Tom
05-26-2004 | 04:35 PM
#2
Senior Member
My Feedback: (1)
Joined: Oct 2002
Posts: 2,707
Likes: 0
Received 0 Likes
on
0 Posts
From: Woodstock, GA
RE: Elevator servo recomendations?
Tom I'd go with at least 60 in/ozs on that elevator assuming you're using 1 servo. Closer to 80 if possible. A JR DS9411SA would be absolutely perfect...but it's pricey.
-Mike
-Mike
05-26-2004 | 06:47 PM
#5
Thread Starter
Senior Member
My Feedback: (12)
Joined: Dec 2003
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
From: Rockledge,
FL
RE: Elevator servo recomendations?
I want a digital on the elevator. If I get enough time to practice with this plane I'll fly in a contest or two and I beleive the elevator servo is important.
05-26-2004 | 09:40 PM
#6
My Feedback: (198)
Joined: Feb 2002
Posts: 6,707
Likes: 0
Received 0 Likes
on
0 Posts
From: El Reno, OK
RE: Elevator servo recomendations?
Get an JR 8231 on RCU in the Radio section....lots of them available, and the nylon gear train will be slop free for a LONG time. I use them on everything but Rudder.
