Hi guys,

Here is few questions for you. For next F3A season i will use OS160FX with Perry pump and tuned pipe. I want too pick up rigt prop ir and fuel for 2m pattern plane with this engine. I gues APC 18x10 is best option for this setup. What you guys think, please share your experience about this engine.

Thanks, 3Don

I use a 16X10 Master Airscrew three blade. Works great. Check out this info also.

http://www.rcaerobats.net/OS160_Setup.htm

Thanks for reply and link, i gues it is good recomendations. But i already have 2 blade spinner, so i want too go with 2 blade prop. Also think too use 18%oil, 10%nitro fuel. Maybe will go with APC 17x13.

Greets 3Don

The 16x10 3 blade master airscrew works very well, I found the speed is much more controllable w/ the Masterairscrew,

How much cost that prop, and where can i buy it?

Here is where you can buy this prop.

http://www.masterairscrew.com/

If you are flying 2 blade, 17x13 APC works well with 15% nitro fuel, Perry pump, Mueller header and Aeroslave pipe.

Jon Lowe