Futaba 10cag help
#1
Senior Member
Thread Starter
Join Date: Jul 2012
Location: , CA
Posts: 433
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 10cag help
How would one program a trim change into the futaba 10cag when flaps are down? Looking to have evaluator trim change when flaps drop to tame a big gasser zero. Any help appreciated.
Bubba
Bubba
#2
Senior Member
My Feedback: (1)
Join Date: Mar 2010
Location: Lewisville, TX
Posts: 171
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 10cag help
It is certainly possible using a mix. I'm setting up a 1/4 scale Super Cub and using the programmable mix functions on my 10CAG I've been able to programtwo different amountsofpredetermined down elevator for both approach flaps and landing flaps using the three way switch.
I can't remember my exact settings but it didn't take long to figure out.
This link may help: www.rcuniverse.com/forum/m_10669700/anchors_10683198/mpage_1/key_/anchor/tm.htm#10683198