Single conversion?
#1
Member
Thread Starter
Join Date: Sep 2003
Location: CabramattaN.S.W., AUSTRALIA
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Single conversion?
Simple question.
Is single conversion 4 channel receiver enough to put on my spirit (2M sailplane) or is it suicide.
Also can I use a hitec single conversion crystal with a JR transmitter crystal??
It says that JR crystals are compatible with every radio on market but are they compatible with other crystals of different bands.
Is single conversion 4 channel receiver enough to put on my spirit (2M sailplane) or is it suicide.
Also can I use a hitec single conversion crystal with a JR transmitter crystal??
It says that JR crystals are compatible with every radio on market but are they compatible with other crystals of different bands.
#3
Senior Member
My Feedback: (13)
Join Date: Jun 2002
Location: Omaha, NE
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
RE: Single conversion?
It really isn't a matter of Single Conversion vs. Dual Conversion. There are very high quality SC receivers on the market...Berg and JR to name a couple. Some park flyer receivers are SC but don't have as much range. So you wouldn't want to use a receiver designed for park flyers on your glider. For a glider I would suggest a high quality receiver. Berg, JR, Airtronics Hitec and Futaba all make good receivers. I prefer Berg myself but that is just me. I'm sure everyone has their favorites.
Kent.
Kent.
#5
Senior Member
Join Date: Sep 2002
Location: Lewisville,
TX
Posts: 669
Likes: 0
Received 0 Likes
on
0 Posts
RE: Single conversion?
Technically, in the dual conversion there are two sets of mixers and intermediate frequencies (and associated filters) rather than one set in a single. Either can perform equally well if properly designed and built.
- Tim
- Tim
#6
My Feedback: (5)
Join Date: Jan 2002
Location: San Tan Valley,
AZ
Posts: 5,768
Likes: 0
Received 0 Likes
on
0 Posts
RE: Single conversion?
In a single conversion receiver a crystal controlled frequency generator operates 455 KC from the transmitted frequency. A mixer circuit converts the received signal to 455kc by subtracting the generated frequency from the received frequency.
A double conversion receiver has two crystal controlled frequency generators. The first one is 10.7 MHZ from the received frequency. The received signal is thus converted to 10.7 MHZ and then fed to the 455kc converter where it is converted to 455kc.
Double conversion helps suppress the image frequency. If you don't know what the image frequency is don't feel bad. I once had to explain it to an electrical engineer with a masters degree.
If you are curious I reccommend that you do a Google search. Its too much to explain here.
A double conversion receiver has two crystal controlled frequency generators. The first one is 10.7 MHZ from the received frequency. The received signal is thus converted to 10.7 MHZ and then fed to the 455kc converter where it is converted to 455kc.
Double conversion helps suppress the image frequency. If you don't know what the image frequency is don't feel bad. I once had to explain it to an electrical engineer with a masters degree.
If you are curious I reccommend that you do a Google search. Its too much to explain here.