MatrixTech

Need link lenghts for tlt-1 crawler mods.

Eric

dezfan

Depends on many factors.

What wheel base do you want to run.

What chassis you are using.

What link plates you are using.

What set up, 50/50, 60/40,

And so on.

MatrixTech

I will be using a stampede trans and axles for drive.I wanna run moabs(already got them).I dont wanna loose all my options but I already cut the bottom 28mm off the chassis.I need to get some recommendations lets say 11.5 inches to start.

Thanks
Eric

MatrixTech

also have available rc-10 b3 buggy for stripping for trans and motor mount
which pede or stealth??

dezfan

What chassis are you planning to use? The Pede and Stealth are both good w/ the Pede being easier for a noob to set up. Who are you using Stampede axles????

Some pics wpuld help.

MatrixTech

I took the stock plates and cut the bottom 28mm off below the holes. I am thinkin pede because of ease unless you can help me locate the axles/shaft I need for the stealth.

Thanks
I will be able to pic in am but there is a site for a pic of what I did.
http://www.uk-microrc.co.uk/forum/in...showtopic=2748

scroll down to plates laying on table.
right above the yoke mod.

dezfan

Still didn't see a Pede chassis or axle. I think you meant TLT.

If so you can use these for your lower links along w/ some TRaxxas rod ends and it should but you in the ballpark.

http://www2.towerhobbies.com/cgi-bin...?&I=LXJVD7&P=7

MatrixTech

Thanks for the info.

yes thats pede tranny w axles