Hanger9 P51 D Mustang 1.50 size ARF
#26
Join Date: Jun 2007
Location: Fort Benning,
GA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hanger9 P51 D Mustang 1.50 size ARF
Hey guys, I do have a saito 180 in a hanger 9 p-51 150. the ferosious frankie. It runs strong as all get out. 18X6 master airscrew prop. Plenty of pull and power. BUT you WILL NOT DO 3D with this setup. I would if i had the money put a 220 saito i would definatly do it but i also thought about going gas. Less Mess on the fuselage. Hope this helps. oh by the way think about going with a 17X6 prop on the saito 180. Bigger is NOT always better!
#28
Join Date: Jun 2007
Location: Fort Benning,
GA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RE: Hanger9 P51 D Mustang 1.50 size ARF
I dont know but if you look at the 21st post on page one you will see where someone asked about 3d with this plane. Just answered the questions on the forum. didnt know someone would have a problem with that. SORRY!!! CHRIST!!
#30
My Feedback: (1)
RE: Hanger9 P51 D Mustang 1.50 size ARF
ORIGINAL: Bounty1977
I dont know but if you look at the 21st post on page one you will see where someone asked about 3d with this plane. Just answered the questions on the forum. didnt know someone would have a problem with that. SORRY!!! CHRIST!!
I dont know but if you look at the 21st post on page one you will see where someone asked about 3d with this plane. Just answered the questions on the forum. didnt know someone would have a problem with that. SORRY!!! CHRIST!!
#31
RE: Hanger9 P51 D Mustang 1.50 size ARF
Well in the 5 1/2 years that have elapsed between your posts and the previous one, somebody might have achieved it and just kept quiet about their astounding success