1/24 Type 90 Tank Problem
12-30-2014 | 10:03 AM
#1
Thread Starter
Junior Member
Joined: Dec 2014
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
1/24 Type 90 Tank Problem
Hello.
I hope I posted this to right sub-forum.
I have 1/24 Type 90 Tank and it was in the box for a while.
Today I took it out and charged battery but tank does not respond. I disassembled it and saw that one wire is broken, and I don't know where to solder it??
Images are too big so I posted links.
Tank
Tank
Circuit board
I hope I posted this to right sub-forum.
I have 1/24 Type 90 Tank and it was in the box for a while.
Today I took it out and charged battery but tank does not respond. I disassembled it and saw that one wire is broken, and I don't know where to solder it??
Images are too big so I posted links.
Tank
Tank
Circuit board
12-30-2014 | 02:29 PM
#2
Member
My Feedback: (1)
Joined: Nov 2012
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
From: Halifax, NS, CANADA
Looking at the board I take it that it's a heng long 1/24 tank? I have 1/24 vstanks I would open up and take a look , but most if not all have cable plugs and are not soldered to the board, so if it is Heng Long then I don't think I can be of help, but I'm sure there must be a schematic for it somewhere on the net. Good luck.
Greg
Greg
12-31-2014 | 12:29 AM
#3
Thread Starter
Junior Member
Joined: Dec 2014
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Yes, it's Heng Long.
thanks
That wire is coming from the battery and it is gnd -
EDIT:
I solved it.
I soldered black wire to the switch.
http://static.rcgroups.net/forums/at...6-DSCF2831.jpg
thanks
That wire is coming from the battery and it is gnd -
EDIT:
I solved it.
I soldered black wire to the switch.
http://static.rcgroups.net/forums/at...6-DSCF2831.jpg
Last edited by deekline; 12-31-2014 at 02:51 AM.
