I searched here, the DAK, and the BAT sites.
I can't seem to find the info I need.

So I managed to bind the receiver to the TX.
I plugged in the channels in 1,2,3,4 order but this does not control the tanks normally.

I want my DX6's right stick to control the tank's movement and have the left stick control the turret.
Can anyone tell me what channel wires from the DMD I stick into which slots on the receiver?
I guess a good answer to know is what does each channel 1,2,3,4 actually control in these tanks?

Thanks! Tak

If you don't have the manual to go with the DMD, I would stick one wire at a time into the receiver ELEV channel and push the right joystick up/down to see what it does.

Receiver Channels:

* THRO (throttle) - Channel 1: left stick up/down
* AILE (aileron) - Channel 2: right stick left/right
* ELEV (elevator) - Channel 3: right stick up/down
* RUDD (rudder) - Channel 4: left stick left/right
* GEAR (retracts) - Channel 5: top left toggle switch
* AUX1 (flaps) - Channel 6: top right toggle switch

Figured it out.

Tamiya channels:
1 Drive turn
2 Drive forward/rev
3 Turret up/down
4 turret rotate

So for Left stick turret and right stick drive I have the following
3 to THR
1 to AILE
2 to ELE
4 to UD

New problem, how to get the guns to fire.
I tried the tutorial off the DAK site and this didn't work, nor does it explain how to get the machine gun to fire.

Does anyone have a DX6 with the right stick for movement and the left for turret?
Can you tell me how to set this radio up to move and fire?

You can reverse the channel in the DX6 transmitter.