Phoenix Models A-26 Invader
09-02-2018, 03:56 PM
#26
My Feedback: (15)
I could not post the details so will do so now
1) 2x60 eflight motors
2) 2 x castle 90 ice with two added capacatators on each side to allow the ECSs to stay on the wing for cooling and not experience any ripple effects.
3) the turret is fully functional in rotation & up and down movement.
4) Full lighting system
5) scratch built interior with working doors and magnetic hatch
6)Cali graphics
1) 2x60 eflight motors
2) 2 x castle 90 ice with two added capacatators on each side to allow the ECSs to stay on the wing for cooling and not experience any ripple effects.
3) the turret is fully functional in rotation & up and down movement.
4) Full lighting system
5) scratch built interior with working doors and magnetic hatch
6)Cali graphics
09-02-2018, 04:34 PM
#27
I see you are using 3 blade props. I used 3 blade on mine with eflite power .60 motors but was disappointed with the top end performance of this plane. I had to fly at or very near full throttle all the time just to get any sort of speed and still felt it was a bit sluggish. Can't fly very long with those throttle settings!
So, my question for you is what is your impression of performance on your setup and what specific props are those in the pictures?
So, my question for you is what is your impression of performance on your setup and what specific props are those in the pictures?
02-05-2019, 06:53 AM
#28
Join Date: Nov 2002
Location: Sterling Heights, MI
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
How many Tx channels are actually required for this A-26 out of the box? The specs say eight, but the wiring diagram in the manual only shows six channels using y harnesses. Thanks.
