does anyone have pics of what the linkage should be set at and what are some of your guys low speed, high speed and idle screws set at?

i am not too sure what linkage your talking about but set the high needle to 2 1/2 out from closed and the low needle flush with the collar around it, this will get you going, i am sure you will need to tune from there.

well as far as linkage the throttle cable and etc

here's pic of the throttle linkage from a lightning but they are the same: http://www.redcatracing.com/picsgallery/lightning7.jpg

because i think mine is all screwed up, and I cant figure out why it wont run, everything else is where it was before, and the manual says if your engine doesnt start to check the linkage.

i think it means to make sure there is a 1mm gap on the carb when at the neutral position, if the carb is closed it wont start.