pullstart screws
01-19-2009 | 10:28 PM
#1
Thread Starter
Senior Member
Joined: Jan 2008
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
From: Perham,
MN
pullstart screws
what is the specific part number of the screws that hold the pullstart onto the engine for the .18?
i know the size is 2*6mm but the only ones i found were self tapping not machined, i found the .07 pullstart screws, are thes the same size?
thanx for your help
i know the size is 2*6mm but the only ones i found were self tapping not machined, i found the .07 pullstart screws, are thes the same size?
thanx for your help
01-20-2009 | 11:33 AM
#2
Senior Member
Joined: Jun 2007
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
From: Mesa,
AZ
01-20-2009 | 02:31 PM
#4
Senior Member
Joined: Jun 2007
Posts: 493
Likes: 0
Received 0 Likes
on
0 Posts
From: Mesa,
AZ
RE: pullstart screws
I am sorry I didn't see that. These are the same thing
http://shopping.netsuite.com/s.nl/c....id.13/.f?sc=14
http://shopping.netsuite.com/s.nl/c....id.13/.f?sc=14
