RCU Forums - Search Results

Search: Posts Made By: LundFalcon

Showing results 1 to 12 of 12
Search took 0.58 seconds.

Forum: Smart-Fly (Quest Engineering) Support Forum

05-12-2009, 04:47 PM

Replies: 3

LED failure on EQ6

Views: 1,015

Posted By LundFalcon

RE: LED failure on EQ6

Great, thanks for your reply!! Then I'll go fly[8D]

Btw, I am know using a JR 921 reciever, and I've read the other posts about not using the BATT connections etc. You mentioned that THRO and...

Forum: Smart-Fly (Quest Engineering) Support Forum

05-12-2009, 03:41 PM

Replies: 3

LED failure on EQ6

Views: 1,015

Posted By LundFalcon

LED failure on EQ6

Hi Robert,

I'm a happy owner of an EQ6, and it has served med well during a couple of years now. It still does, but I found out that the green LED on channel 7 came loose, and only works if I...

Forum: Giant Scale Aircraft - 3D & Aerobatic

06-09-2008, 12:26 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

I read that somewhere in this forum, but I believed it to be a "tall story"..... Has it been testet yet? To my understanding 3W never mentioned this in their manuals[:o]

Yes, I run the 3w M50...

Forum: Giant Scale Aircraft - 3D & Aerobatic

06-08-2008, 10:38 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

I have now made the changes and tested the setup. The rear baffle hasn't been necessary..

Five test flights yesterday (a very hot day in Denmark 85 dg. F.) with temp readings just seconds after...

Forum: Giant Scale Aircraft - 3D & Aerobatic

06-05-2008, 03:49 PM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Yes of course you are right [sm=red_smile.gif]!!![:@]

I'll try the following changes:
- change the angle of the lower baffle upwords to let the air go up!
- cut off 1-2 cm of the upper...

Forum: Giant Scale Aircraft - 3D & Aerobatic

06-05-2008, 06:21 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Let us see your baffling, on the Extra 260[8D]
My 106i (CS) was for sure running hot, if I didnt baffle.... But I still havent got the temp below 205 *F.
How have you done it?

//Michael

Forum: Giant Scale Aircraft - 3D & Aerobatic

04-25-2008, 06:15 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Hi Andy,

The total lenght needed is 53 mm. if using a 3w 106i. I did not use the alu ones but made a wooden spacer instead.

//Michael

Forum: 3D Flying!

04-09-2008, 04:51 PM

Replies: 547

Bling 3D 50cc ARF

Views: 80,369

Posted By LundFalcon

RE: Bling 3D 50cc ARF

Hi there,

I can't find a manual for the Bling, and need to check if it's possible to use cans. Due to noiserestrictions in-cowl muflers aren't good enough.

I'm going for a DA-50 and a KS...

Forum: Giant Scale Aircraft - 3D & Aerobatic

01-30-2008, 04:15 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Thanks for your answers,

I've decided to use "Knuckleheaders" from MTW and Can's from 3W- so now I don't have to worry about headerdrop, just bend in place, and solder (a bit):)

It seems...

Forum: Giant Scale Aircraft - 3D & Aerobatic

01-28-2008, 04:15 AM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Hi,
Iâ€™m installing a 3W 106 on my Extra and I would appreciate if someone using the same engine could post some pictures/ideas regarding mounting, header drop, spacer distance etc. This is my...

Forum: Giant Scale Aircraft - 3D & Aerobatic

01-24-2008, 06:30 PM

Replies: 502

H-9 Extra 260

Views: 49,883

Posted By LundFalcon

RE: H-9 Extra 260

Hi there,
It's with great interest that I've read all the above...

This plane has just entered Denmark, and I expect to recieve my "two boxes" next week:D.

I've decided to go for the 3W...

Forum: Giant Scale Aircraft - 3D & Aerobatic

08-04-2007, 05:46 PM

Replies: 851

Aero-Works 50cc Yak

Views: 100,975

Posted By LundFalcon

RE: Aero-Works 50cc Yak

Hi Mark,
I just wondered if you have other "spareparts" available, such as the LG-cover and a LG update kit for a blue schemed 50cc Yak? (I newer recieved the update kit!!)

I have wrecked my...

Showing results 1 to 12 of 12