RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: justahobbie
Showing results 1 to 25 of 40
Search took 0.68 seconds.
Forum: Giant Scale Aircraft - 3D & Aerobatic
06-19-2007, 02:44 AM
Replies: 3
Views: 1,476
Posted By justahobbie

1/2 Scale Extra 300

My parents and I own a local Hobby Shop, and my Dad and I have been talking about scratch building a 1/2 scale Extra just to say we did. I know it's been done before, but I have been searching...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
04-12-2007, 02:04 PM
Replies: 0
Views: 661
Posted By justahobbie

9303 Mini Ultra Stick programming servo speed problem

I just got all the servos installed in my Mini Ultra Stick last night. I set it up per Horizon Hobby's Quad flap setup. See set-up below:

Ch 2 - Right Aileron
Ch 5 - Left Aileron
Ch 6 -...
Forum: Crash & Rebuild
09-18-2006, 12:39 AM
Replies: 32
Views: 4,410
Posted By justahobbie

RE: Forensic crash investigators needed ! ! !

Anyone have this video?
Forum: Crash & Rebuild
09-18-2006, 12:13 AM
Replies: 3
Views: 1,033
Posted By justahobbie

Looking for video of Bill Hempel landing safely with 1 wing.

Just like the title says. I heard at the field today of a 40% that lost a wing panel in flight, and the pilot rolled it knife edge and brought it in. I have searched and found nothing. Now when I...
Forum: The Clubhouse
06-21-2006, 12:53 AM
Replies: 1
Views: 584
Posted By justahobbie

Part Time Job Opportunity at Local Hobby Shop in Washington State

All

We at Tumwater Hobby are looking for an experienced person to help us cover a few shifts a week. R/C experience is required, preferrably in airplanes or helicopters. Will entertain persons...
Forum: JR Radio & Spektrum Radios
08-11-2005, 12:05 PM
Replies: 3
Views: 744
Posted By justahobbie

RE: 'm just now getting into J

Thanks Danny

Answers a lot of questions, but just one more.

Is the JRPXFR** crystal the correct one to use in the PCM R770 receiver, or is there a special PCM crystal. I noticed the...
Forum: JR Radio & Spektrum Radios
08-11-2005, 03:12 AM
Replies: 3
Views: 744
Posted By justahobbie

'm just now getting into J

Hello

I'm just now getting into JR from Futaba and started using a 8103 I got from a buddy. I just found out that most receivers are single conversion, and just as a curiousity, how do they...
Forum: RC Jets
07-29-2005, 06:57 PM
Replies: 32
Views: 3,242
Posted By justahobbie

RE: I just recieved this SCAM offer on RCU

I got a scam offer too. Can someone report it for me? I cant find it.

Thanks
Ryan



------------MESSAGE SENDER------------

MEMBER ID: 192221
Forum: ARF or RTF
09-21-2004, 01:40 AM
Replies: 31
Views: 4,162
Posted By justahobbie

RE: Dave Patrick Models Customer Service?

So you were told she would let you know when they were avaliable and got no response and had to email her again?

Then they don't pick up the phone all day?

Somebody's got my money they had...
Forum: Batteries & Chargers
09-21-2004, 01:26 AM
Replies: 13
Views: 921
Posted By justahobbie

RE: CHARGING LARGE PACKS AT LESS THEN 10%

Odd. I guess Futaba and everyone else screwed up when they gave out 50mah chargers for their 600mah packs.

Come on now.

I use that 140% charge time figure too and it works great.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-22-2004, 12:28 AM
Replies: 5
Views: 648
Posted By justahobbie

RE: When is it time to recharge?

Thanks guys. Info is helping out a lot. I think I'm going to return that Hobbico ESV.

I could use some more opinions. Keep em comming!

Ryan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-21-2004, 02:55 PM
Replies: 5
Views: 648
Posted By justahobbie

When is it time to recharge?

Need a little help. Can't find this info anywhere.

I have a new FuntanaS 90 with 5 JR 8411 servos and 1 537 servo. I am using a 6V 1400mAH pack. I can't find current draw for these servos. I...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
07-14-2004, 12:46 AM
Replies: 0
Views: 502
Posted By justahobbie

Duralites. Need info.

What exactly are Duralites and why is (or was) everyone using them in their planes? What kind of cells are they and what kind of charger do you need to charge them?

Just need advantages and...
Forum: 3D Flying!
07-14-2004, 12:17 AM
Replies: 59
Views: 6,167
Posted By justahobbie

RE: So, What engine is voted best Funtana 90?

They also state how important it is to seal the hinge gaps. It's all good though. Sounds like you caught it before you lost your plane.
Forum: 3D Flying!
06-14-2004, 11:33 PM
Replies: 3
Views: 526
Posted By justahobbie

RE: U-can-do servo question.

True true. I keep thinkin about putting something stronger in mine cause I know I'm gunna stress it. Even though GP says standard on the ailerons and elevators are ok it really depends on your...
Forum: 3D Flying!
06-14-2004, 01:17 AM
Replies: 3
Views: 526
Posted By justahobbie

RE: U-can-do servo question.

Sounds fine to me. I wouldn't go and buy them though. If your gunna buy servos might as well go with something stronger for the money. I have the UCD 60 and I'm putting 3001's in mine cause I...
Forum: 3D Flying!
06-14-2004, 12:39 AM
Replies: 12
Views: 1,183
Posted By justahobbie

RE: Funtana Electric

Mine is on order. I want to have the first one. I'm also thinkin about building the large scale kit.

Are they making them in white and yellow? The one I saw was white.

Ryan
Forum: IMAC
06-13-2004, 11:36 PM
Replies: 22
Views: 3,932
Posted By justahobbie

RE: Throttle Servo for GAS engines

What is the deal with servos going dead on the throttle? Is it just the vibration of the gas engine? I'm a little new to the large scale gas scene.

Ryan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-13-2004, 12:07 PM
Replies: 15
Views: 3,416
Posted By justahobbie

RE: How to RAIN PROOF a transmitter unit!

Ya thats pretty expensive. I have an 8U but I been pretty good about keepin it dry. John-were you at TCMAA Saturday for the bid bird? You avatar looks familiar.

Ryan
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-13-2004, 01:12 AM
Replies: 0
Views: 404
Posted By justahobbie

Rubber Whip Antenna for 8UAFS

Short and sweet...

Does anyone make one?

and

Can they be trusted? Any range specs? Would you fly your $3000 IMAC ship with it?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-13-2004, 01:07 AM
Replies: 15
Views: 3,416
Posted By justahobbie

RE: How to RAIN PROOF a transmitter unit!

Looks like you could hold the pistol with one hand and slip your other hand into the other slot to operate the wheel.

I need onme of those. I always fly in the rain. I don't got to the field...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-13-2004, 12:52 AM
Replies: 1
Views: 475
Posted By justahobbie

RE: High-torque servo

High Torque would be good on the rudder if you plan on doing aerobatics or 3D. I think a 9202 would be fine but something a little stronger woujldnt hurt. I'm just not real familiar with the plane....
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
06-13-2004, 12:15 AM
Replies: 5
Views: 541
Posted By justahobbie

RE: JR 8411 to Futaba receiver??

Ya nothings gunna blow. If they are reversed I believe the servo gets no power cause only the positive wire is plugged into the proper slot. Good that your being careful though. Radio gear is not...
Forum: RC Flight Simulator Software
06-12-2004, 11:46 PM
Replies: 4
Views: 391
Posted By justahobbie

RE: I'm trying to load it on my mom's computer, but I can't....??

Tell your dad to open up the Real Flight Control Panel. You don't need the CD and if you registered it the serial # is right at the top. I think your the one that replied in my other post? You can...
Forum: RC Flight Simulator Software
06-12-2004, 11:39 PM
Replies: 4
Views: 583
Posted By justahobbie

RE: HELP!!! RF G2 USB Adapter Doesn't Work

I currently have G2 loaded on 3 of my machines and they all run fine. When you register it to get the updates just be sure you remember you use the same password or it will not work. If you need to...
Showing results 1 to 25 of 40
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.