RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: X-cell Fury
Showing results 1 to 25 of 114
Search took 0.55 seconds.
Forum: Marketplace
01-07-2022, 09:45 AM
Replies: 0
Views: 805
Posted By X-cell Fury

Baby Boomerang Intro ready to fly with JetCat P60 Kerosene Start

This is my Baby Boomerang that I bought at the height of my interest in aeromodelling but sadly it dwindled not long after. I kept hold of it for a number of years but my enthusiasm hasn't reignited...
01-23-2014, 03:10 AM
Replies: 2
Views: 3,277
Posted By X-cell Fury

Phoenix Model Downloads

Haven't used sim for a long time and am looking for new models. I vaguely remember there was a website for sharing models created for Phoenix but can't find anywhere, can anyone point me in the...
01-23-2014, 02:06 AM
Replies: 5
Views: 1,048
Posted By X-cell Fury

Sorted! Connected the fuel pump directly to...

Sorted!

Connected the fuel pump directly to the JetCat battery and after switching it on and off a few times it jolted free.

Thank you again for the help.

Andy
01-21-2014, 06:12 AM
Replies: 5
Views: 1,048
Posted By X-cell Fury

I have managed to borrow another pump and...

I have managed to borrow another pump and solenoid to aid diagnostics. Will report back.
01-21-2014, 04:07 AM
Replies: 5
Views: 1,048
Posted By X-cell Fury

Good suggestion, thank you.

Good suggestion, thank you.
01-21-2014, 03:46 AM
Replies: 5
Views: 1,048
Posted By X-cell Fury

JetCat P-80 Failed Starts

Hi,

Tried starting my P-80 this morning but it constantly fails and I have attached a video of the startup procedure (hopefully, if it works)! It's been a few years since I lasted started it (not...
04-07-2009, 10:29 AM
Replies: 4
Views: 725
Posted By X-cell Fury

RE: Long term storage of NiCd’s

Thank you for your reply but I was hoping for something a little less complicated!!!
04-06-2009, 12:18 PM
Replies: 4
Views: 725
Posted By X-cell Fury

Long term storage of NiCd’s

Is there a way of preparing NiCd receiver packs for long term storage like we would Li-Po’s?

I checked my charger but it doesn’t have a storage option for NiCd’s.

The reason I ask is...
Forum: 3D Flying!
03-21-2009, 11:13 AM
Replies: 2
Views: 562
Posted By X-cell Fury

Forum: 3D Flying!
03-19-2009, 01:42 PM
Replies: 2
Views: 562
Posted By X-cell Fury

C of G for Ripmax Xtreme

I have a Ripmax Xtreme that I’m gonna dust off for the weekend but I can’t find the manual or remember where the c of g is supposed to be!!!

Can anybody assist?

Thanks in advance

...
Replies: 8
Views: 1,738
Posted By X-cell Fury

RE: JR PCM 10X Programming

Ok I’m confused!

I want to programme my transmitter so that when I flip my gear switch the servos plugged into gear and aux 2 moves.

I then want to be able to adjust the travel of each...
Forum: RC Jets
05-27-2008, 02:30 PM
Replies: 8
Views: 1,738
Posted By X-cell Fury

RE: JR PCM 10X Programming

Trying to avoid a y-harness so I can adjust travel on each servo, I shall have a look at those p-mix.
Replies: 8
Views: 1,738
Posted By X-cell Fury

JR PCM 10X Programming

I’m just after a little programming advice for my JR PCM 10X:

I’m building a plane that has a set of mechanical retracts that requires two servos to operate (one for front and one for...
11-19-2007, 11:33 AM
Replies: 5
Views: 637
Posted By X-cell Fury

RE: DualSky Li-Po and TP210 – are adaptors required?

Thanks for the reply - I had a look at their site but am confused!!!

Could you perhaps show me the lead I need?

Thank you
11-17-2007, 07:32 PM
Replies: 5
Views: 637
Posted By X-cell Fury

DualSky Li-Po and TP210 – are adaptors required?

Hi,

I have just ordered a DualSky Li-Po as per the link below for one of my foamies.

I already ready have the TP1010 and TP210 balancer and would like to know is the battery I have just...
11-08-2007, 12:34 PM
11-08-2007, 12:03 PM
Replies: 4
Views: 786
Posted By X-cell Fury

A little help with simple calculations please

Just after a quick bit of info – basically I bought the Sullivan battery box and it came with a charger but unfortunately for me a two-pin starter!

So I have decided I shall use my Grauper...
Forum: RC Jets
10-22-2007, 12:13 PM
Replies: 13
Views: 5,124
Posted By X-cell Fury

RE: Baby boomerang and Jet 1A Retracts

I guess that is like swearing in a jet forum :D




That would be great, PM sent - thank you [sm=thumbs_up.gif]
Forum: RC Jets
10-20-2007, 04:28 PM
Replies: 13
Views: 5,124
Posted By X-cell Fury

RE: Baby boomerang and Jet 1A Retracts

Well if I remember rightly the manual says to have the nose leg 10mm shorter than the mains to prevent bounce on landing.

Haven't mocked it yet just at the very initial stages but I am defo...
Forum: RC Jets
10-20-2007, 05:59 AM
Replies: 13
Views: 5,124
Posted By X-cell Fury

RE: Baby boomerang and Jet 1A Retracts

I can not remember who I took these pictures from to give them credit but they came from the 109 page boomerang thread and so far seem the best way for me to mount my leg.

...
Forum: RC Jets
10-20-2007, 05:47 AM
Replies: 13
Views: 5,124
Posted By X-cell Fury

RE: Baby boomerang and Jet 1A Retracts

http://img.photobucket.com/albums/v414/Fury20/CIMG059.jpg
Forum: RC Jets
10-20-2007, 05:29 AM
Replies: 13
Views: 5,124
Posted By X-cell Fury

RE: Baby boomerang and Jet 1A Retracts

Thanks for replies guys [sm=thumbup.gif]

highhorse - thanks for pics, very helpful. I have just noticed that everybody has their retracts shorter than mine - glad I noticed that before I start...
Showing results 1 to 25 of 114
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.