RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: CHARGER0_6
Showing results 1 to 23 of 23
Search took 0.51 seconds.
Forum: RC Warbirds and Warplanes
08-18-2010, 11:59 AM
Replies: 0
Views: 257
Posted By CHARGER0_6

can it sell

I HAVE ACOX T-28 ITS ABOUT 90% FINISHED I GETTING OUT OF WARBIRDS AND WONDERED IF THERE IS ANY INTEREST INTHIS PLANE
Forum: RC Warbirds and Warplanes
11-19-2009, 12:46 PM
Replies: 2
Views: 774
Posted By CHARGER0_6

p47 canopy

I recently purchased used a hangar9 p47-150. Problem is all screws in pilot compartment are not lining up, there is a gap between mounting surfaces. How do i correct the problem?
Forum: Gas Engines
06-10-2009, 10:42 AM
Replies: 1
Views: 578
Posted By CHARGER0_6

is carb plate turned wrong way

I HAVE A ZENOAH 45 ENGINE WILL START ONLY AFTER PRIMING AND THEN COVERING PORT WITH THUMB THEN RUNS ALL OUT.WHICH WAY DOES CARB BUTTERFLY FACE /HEAD OF SCREW OUT OR IN.</p>
Forum: RC Warbirds and Warplanes
05-21-2009, 06:58 AM
Replies: 12
Views: 1,016
Posted By CHARGER0_6

how to set flap control

i have a futaba 9c iam trying to setup flaps on a three position switch any suggestions on how to do it woud be helpful this is my first war bird and a different radio i am trying to learn how to...
Forum: Car Nitro & Gas Engines
03-25-2009, 03:04 PM
Replies: 3
Views: 469
Posted By CHARGER0_6

ugh

i have an older tower axis /hard to start / have had to turn hi needle out at least 6 turns to start book says 1.5 to 2.5 / to rich any ideas on how i should adjust carb would be welcomed
Forum: RC Warbirds and Warplanes
01-16-2009, 08:50 AM
Replies: 3
Views: 704
Posted By CHARGER0_6

RADIO SETUP

I AM TRYING TO SET FLAP CONTROL ON A P47. I HAVE A FUTABA 9C TRANSMITTER. I AM USING SWITCH C WHICH IS A 3 POSITION. THE MANUAL DOESNT GO INTO DETAIL AS TO HOW TO DO THIS AND I AM HAVING TROUBLE....
Forum: Crash & Rebuild
01-10-2009, 01:02 PM
Replies: 6
Views: 877
Posted By CHARGER0_6

aileron positioned to high

bought a set of wings for a hangar9 p47-150 person installed robart hinges but are set too high . how do you remove them without any damage
Forum: RC Warbirds and Warplanes
11-14-2008, 09:56 AM
Replies: 2
Views: 701
Posted By CHARGER0_6

HANGAR9 P47 150 TAIL WHEEL

WHAT MOD IS DONE TO ELIMINATE BIND OTHER THAN ADDING ANOTHER SERVO
Forum: RC Warbirds and Warplanes
09-03-2008, 03:15 PM
Replies: 1
Views: 686
Posted By CHARGER0_6

COX T28

I JUST PURCHASED A T28 FROM MY LOCAL SHOP,OUT THE DOOR 400/HAVE A G26, IS THIS ENOUGH POWER,WILL IT FIT IN THE COWL/ RETRACTS WILL BE THE SPC UNITS/IS THIS PLANE GOOD FOR A FIRST TIME WARBIRDER
Forum: RC Scale Aircraft
06-05-2008, 08:40 AM
Replies: 4
Views: 1,245
Posted By CHARGER0_6

LANDING GEAR

THE LANDING GEAR ON MY PITTS NEEDS TO BE REINFORCED OUR BRACED IT CONSTANTLY BENDS ON LANDING/ HAS ANYONE MADE STRUTS TO CONTROL THE FLEX OR PRODUCES STUDIER GEAR
Forum: RC Truggy
05-22-2008, 11:31 AM
Replies: 6
Views: 766
Posted By CHARGER0_6

st-1 trouble

DOES ANYONE MAKE BEEFED UP ST. TIE END FOR THE ST-1 THEY SEEM CHEAP BREAK VERY EASY
Forum: RC Truggy
05-22-2008, 09:56 AM
Replies: 7,956
Views: 628,391
Posted By CHARGER0_6

RE: Thunder tiger ST-1

DOES ANYONE MAKE BEEFED UP ST. TIE END FOR THE ST-1 THEY SEEM CHEAP BREAK VERY EASY
Forum: RC Truggy
05-19-2008, 11:38 AM
Replies: 2
Views: 360
Posted By CHARGER0_6

WHERE TO GO

I LIVE IN THE METRO DETROIT, MI AREA AND RUN 1/8 SCALE TRUCK AND BUGGY ANYONE KNOWS WHERE TO RACE
Forum: RC Truggy
05-19-2008, 11:36 AM
Replies: 0
Views: 339
Posted By CHARGER0_6

WHERE TO GO

I LIVE IN THE METRO DETROIT, MI AREA AND 1/8 SCALE TRUCK AND BUGGY ANYONE KNOWS WHERE TO RACE
Forum: RC Truggy
05-13-2008, 06:58 PM
Replies: 1
Views: 457
Posted By CHARGER0_6

STI WHEELS/TIRES

I NEED TO PURCHASE SOME NEW WHEEL AND TIRES FOR MY TRUGGY(ST1) TO RUN ON ASPHALT.WHO MAKES STREET TIRES AND WHEELS? I.D LIKE CHROME REPLACEMENTS WITH LOW PROFILE TIRES.
Forum: RC Warbirds and Warplanes
03-19-2008, 11:53 AM
Replies: 2
Views: 499
Posted By CHARGER0_6

NEED 2 BALANCE

I AM HAVING A PROBLEM BALANCING MY HANGAR9 P47 IT HAS AIR RETRACTS/ DO U BALANCE WITH GEAR UP OR DOWN/ IS PLANE INVERTED WHEN BALANCING GEAR POINTING UP OR DOWN
Forum: RC Warbirds and Warplanes
11-09-2007, 09:12 AM
Replies: 1
Views: 557
Posted By CHARGER0_6

WINTER PROJECT

I HAVE A NEW G26 TAKEN FROM A H9 P47 150.(UPGRADED TO A G45).THINKING ABOUT PUTTING IT IN A H9 P47 60 DO YOU THINK IT WILL FIT/WOULD IT FIT THE NEW H9 SUNDOWNER. WHAT WOULD BE A GOOD PLANE FOR THIS...
Forum: Gas Engines
10-14-2007, 04:21 PM
Replies: 8
Views: 792
Posted By CHARGER0_6

GETTING NO GAS

IVE JUST INSTALLED A NEW G45 IN MY P47 ENGINE WILL NOT START. SEEMS LIKE ITS NOT GETTING GAS. LINES ARE RIGHT .TRY AND PRIME IT AND THERES NO GAS GOING TO CARB. REMOVED CARB AND TRIED TO BLOW THRU...
Forum: RC Warbirds and Warplanes
09-06-2007, 08:17 AM
Replies: 3
Views: 726
Posted By CHARGER0_6

will it fit

i m building a hangar9 p47 150/ i installing a g45 / how much cowl interfernce should i expect/ already have motor.is it that difficult to install
Forum: Gas Engines
09-03-2007, 04:44 PM
Replies: 10
Views: 1,438
Posted By CHARGER0_6

NO LIFT

I HAVE A NEW G26 MOUNTED IN A HANGAR9 P47 / IT HAS A 16X6 PROP TURNS ABOUT 9300 RPM. I FLY ON GRASS. IT TAKES 3/4 0F THE RUNWAY AND STILL NOT AIRBORNE. WHATS UP/ WILL A G45 PROVIDE ADEQUATE POWER OR...
Forum: Airplanes - Full Scale
08-20-2007, 09:24 AM
Replies: 6
Views: 1,678
Posted By CHARGER0_6

balancing biplane

i have a cox ultimate biplane with a 52 saito 4s. manufacture says cg to lower wing. i dont seem to get it balance. move battery and added lead still nogo. seems to balance on upper wing right on. ...
Forum: Gas Engines
07-21-2007, 12:35 PM
Replies: 5
Views: 1,021
Posted By CHARGER0_6

ENGINE WILL NOT IDLE

I BOUGHT A HANGAR 9 P47 BUILT IT HAS NEW ZENOAH 26. MOTOR ONLY STARTS AND RUNS AT NEAR OR FULL THROTTLE. WHEN I THROTTLE DOWN TO IDLE SPEED ITS DIES OFF. IVE ADJUSTED LOW SPEED NEEDLE TO NO AVAIL ANY...
Forum: Gas Engines
07-18-2007, 02:29 PM
Replies: 3
Views: 558
Posted By CHARGER0_6

ENGINE TROUBLE

[8D]I HAVE BOUGHT P47 WITH ZENOAH G26 ENGINE NEVER RAN I CAN ONLY START IT AT FULL THROTTLE SHUT DOWN AT IDLE ANY SUGGESTIONS/ I WAS ALSO TOLD TO CG IT WITH RETRACTS IN DOWN POSITION IT HAS ROBARTS...
Showing results 1 to 23 of 23


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.