RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: wdps34
Showing results 1 to 25 of 28
Search took 0.50 seconds.
03-04-2008, 12:04 PM
Replies: 4
Views: 1,383
Posted By wdps34

RE: blade 400- seems like im flying the tail

bad gyro from the factory. i armed the esc and gyro, rudder test fine(expected direction for rudder input) but i get no rudder movement when i quickly move the tail. my gain is 72%.

What do...
03-02-2008, 11:32 PM
Replies: 4
Views: 1,383
Posted By wdps34

blade 400- seems like im flying the tail

just got a blade 400. cant get the tail under control set the rate to 80% and expo to +30%. the tail left then when i put in rudder it goes to far right and begins again. help please
02-20-2008, 03:46 AM
02-18-2008, 08:46 PM
02-17-2008, 08:32 PM
Replies: 16
Views: 1,089
Posted By wdps34

RE: cheap e bay brushless setup

here is the esc i got with it http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWNX:IT&item=290202580088&_trksid=p3984.cWON.m313.lVI

i didnt get a program card im just using the...
02-16-2008, 10:24 PM
Replies: 16
Views: 1,089
Posted By wdps34

RE: cheap e bay brushless setup

yeah both for 40 bucks shipped. some low speed initial cogging on take off, would a better battery help that or should i go smaller pinon. im using the stock pinion now
02-16-2008, 08:47 PM
Replies: 16
Views: 1,089
Posted By wdps34

RE: cheap e bay brushless setup

its only 10c, might be holding the combo back a bit
02-16-2008, 08:45 PM
Replies: 16
Views: 1,089
Posted By wdps34

RE: cheap e bay brushless setup

commonsencerc 7.4v 800mah lipo from my blade cx2
02-16-2008, 08:36 PM
Replies: 16
Views: 1,089
Posted By wdps34

cheap e bay brushless setup

i just recieved my 5200kv brushles and esc from this guy on ebay(hkp2ps2) for my MLST2. much faster and torqier except from initial stand still. i paid 40 USD shipped. what do you guys think of it...
02-13-2008, 11:48 AM
Replies: 5
Views: 661
Posted By wdps34

02-12-2008, 07:49 PM
Replies: 5
Views: 661
Posted By wdps34

3,4 and 5 blade heads?

what is the advantage/disadvantage over 2 blade and a flybar
01-17-2008, 06:22 PM
Replies: 3,249
Views: 204,384
Posted By wdps34

RE: Mini LST

thanks robwiljas
01-17-2008, 05:44 PM
Replies: 3,249
Views: 204,384
Posted By wdps34

RE: Mini LST

hey finally got my MLST2 today. wife brought me a mini slider for christmas but i returned it for the mlst2, it was a long wait. anyway this truck seems awful loud to me, is that normal? i never...
12-16-2007, 04:02 PM
Replies: 0
Views: 370
Posted By wdps34

micron fp heli battery

anyone using the micron fp 250ma battery? how is the performance/runtime compared to the losi lipo
12-16-2007, 02:40 PM
Replies: 10
Views: 2,476
Posted By wdps34

RE: micro t atomic bb

what are street meats? i go in and out of the hobby so im not up on the lingo.
12-16-2007, 01:47 PM
Replies: 10
Views: 2,476
Posted By wdps34

RE: micro t atomic bb

is the brushless faster? ive heard people say its not. i can imagine it adds some weight. does the brushless increase run times? does the brushless have the low end grunt(tourqe)?
12-15-2007, 03:27 PM
Replies: 1
Views: 484
Posted By wdps34

taking weight off micro T

today i just dissassembled my micro t and took the dremel to the bottom of the chassis, below raido compartment and to of servo area. i was thinnking of removing the4 x-supports in the suspenion...
12-15-2007, 01:23 PM
Replies: 10
Views: 2,476
Posted By wdps34

micro t atomic bb

a few questions. i just got a micro t and did the lipo, wheel bearings, and atomic bb. i still need the gear box bearings.

1 do i need the 2 gearbox bearings?
2 do i have to break in the...
04-08-2006, 05:03 PM
Replies: 118
Views: 23,210
Posted By wdps34

RE: rc-expert.com

I saw a trex 450 se kit on e bay with motor, esc, gyro, servos and two batteries(18oomah 12c and 2200mah 18c), 3 cell smart charger and a few other extras like carbon blades. I e-mailed them and...
04-07-2006, 09:10 PM
Replies: 10
Views: 819
Posted By wdps34

RE: Question if I may. Blade CP

On my blade i added two flybar weights to each flybar paddle and the bell hiller mixer upgrade. The combination really made it stable and easy to hover. I could land it on a 20"X 28" coffee table...
Forum: T-Rex heli
04-06-2006, 02:35 PM
Replies: 7
Views: 843
Posted By wdps34

RE: T rex se for $500 good buy?

I worked out a deal with benny from rc expert for that package minus the gyro for $500usd even. At the time his buy it now for that package was $560 , I think
Forum: T-Rex heli
04-06-2006, 02:34 PM
Replies: 7
Views: 843
Posted By wdps34

RE: T rex se for $500 good buy?

hers the link: http://cgi.ebay.com/ALIGN-Trex-T-rex-450SE-V2-CDE-RC-Helicopter-ComboKit-ho_W0QQitemZ6049391483QQcategoryZ2563QQcmdZViewItem
Forum: T-Rex heli
04-05-2006, 02:30 PM
Replies: 7
Views: 843
Posted By wdps34

RE: T rex se for $500 good buy?

I checked the package i do have the 430 motor. I traded in my blade cp for a 401 at the local hobby store. Now i just have to figure out what radio. any suggestions?

I too ordered from...
Forum: T-Rex heli
04-04-2006, 06:12 PM
Replies: 7
Views: 843
Posted By wdps34

T rex se for $500 good buy?

I just ordered an se with 420 motor ,35amp speed control, rc expert servos(4 pieces), rc expert 3 cell smart charger, xtrem power 1800mah 12c and 2200mah 18c batteries. Is this a good buy? Too...
01-29-2006, 06:53 PM
Replies: 4,787
Views: 527,216
Posted By wdps34

RE: E-FLIGHT BLADE CP

Anyone have any info on the bell-hiller head from e flight? I just snaped the ball linkage from my flybar cage and thought it would be a good time to switch to the honey bee cp2 head. But if the...
Showing results 1 to 25 of 28
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.