RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
Search: Posts Made By: Trooper-RCU
Showing results 1 to 14 of 14
Search took 0.69 seconds.
08-11-2003, 01:55 PM
Replies: 1
Views: 442
Posted By Trooper-RCU

120 Surpass II running lean and needle valve screwed all the way out!?

My OS Surpass II is running lean at high RPM and the needle valve is turned as far out as is possible without it falling out.
This engine is a pumped engine and even though it s pre 97, is new...
06-18-2003, 04:17 PM
Replies: 7
Views: 854
Posted By Trooper-RCU

10X

I take it from the silence that no one else has had this problem!!!
06-10-2003, 09:48 PM
Replies: 7
Views: 854
Posted By Trooper-RCU

JR 10X wont work with my RF G2

I was useing a futaba Tx and have since switched to JR 10X and now when I try to run RF G2 I cant control the plane???????
06-09-2003, 12:27 AM
Replies: 10
Views: 1,718
Posted By Trooper-RCU

JR

I have tested on a seperate battery pack and it blew fuses in all. This has been inside or outside the Transmitter.

My biggest Question is if I jump the fuse in the battery pack........will...
06-08-2003, 12:55 PM
Replies: 10
Views: 1,718
Posted By Trooper-RCU

JR

Yes, I have swapped polarity on the charger! I have a JR reverser.
06-07-2003, 08:29 PM
Replies: 10
Views: 1,718
Posted By Trooper-RCU

My Sirius Pro Series Charger and JR 10X???

My Sirius Pro series charger keeps blowing fuses in the battery pack on my 10X???????? What gives??
Forum: 3D Flying!
07-12-2002, 01:10 AM
Replies: 32
Views: 1,827
Posted By Trooper-RCU

Top Cap Engine

I just completed all but mounting my engine on my new Top Cap. I will be running a Saito .91 GK (had the engine..........what tha H_ _ _!!! Not planning on making it a speed demon, Just a hover...
05-07-2002, 12:26 PM
Replies: 0
Views: 420
Posted By Trooper-RCU

RF G2 (High and Low throw)?

I am useing a Futaba 8UAF with RF G2 with an interface and cant seem to figure out how to get my high and low throws set up on a switch instead of the turn knob..
Forum: Kit Building
04-12-2002, 09:55 PM
Replies: 19
Views: 3,103
Posted By Trooper-RCU

Flaps

I'm sure that those of you who fly flaps wont agree with this but I've been flying my Texan for 2 years and I see no need in flaps on this particular plane. This plane has some tendencies to snap...
Forum: Kit Building
04-10-2002, 02:28 AM
Replies: 19
Views: 3,103
Posted By Trooper-RCU

AT-6

I have one of the same and it's powered by an os-1.08 swinging a 15x8 Master Airscrew. It's not slow by any means and mine doesn't have retracts!! I think the G 23 would be a GREAT combination if...
04-05-2002, 01:19 PM
Replies: 3
Views: 1,131
Posted By Trooper-RCU

8UAF Super Transmitter Module

I have a new Super 8 Transmitter that I want to change the freq. from #21 to #58 If sent back to Futaba will they just change the crystal or will they swap me a new #58 module? Any idea of...
Replies: 0
Views: 432
Posted By Trooper-RCU

DELETE

Has anyone ever tried to change the crystal in the transmitter module??
WILL IT WORK???????
Replies: 6
Views: 3,136
Posted By Trooper-RCU

Servos

I fly the TS-71 along with the Hitec 615-MG in my 1/3 330L. They are a Great servo for the price. I have mine set up on a 6 volt system and that increases the torque to 133 oz-in. I dont think you...
03-26-2002, 02:03 AM
Replies: 3
Views: 1,110
Posted By Trooper-RCU

1/4 Scale Cub Cockpit ???

Where can I find Items for my 1/4 scale cub?
(seats, throttle, stick and rudder pedals)
Showing results 1 to 14 of 14


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.