RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Dhenry
Showing results 1 to 18 of 18
Search took 0.43 seconds.
Forum: Electric RC Jets
01-13-2012, 04:57 AM
Replies: 0
Views: 711
Posted By Dhenry

Looking for an EDF education

Hi folks,

I have been combing through the Internet looking for information on how to select power a system for an EDF. Starting with how many watts per pound for performance factors, fan...
Forum: Electric RC Jets
06-25-2009, 07:05 AM
Replies: 24
Views: 5,278
Posted By Dhenry

RE: Hobby-Lobby F-18 don't fly!!!

My wingtips were swept up and the ailerons would only match with the inside or outside of the wing. Tried to line them up both ways and each time it rolled inverted. Like you say nice looking, but...
Forum: Brushed/Brushless motors, speed controls, gear drives
08-23-2007, 08:08 AM
Replies: 5
Views: 950
Posted By Dhenry

RE: motor current

What is the 3600?
Forum: Kit Building
08-03-2007, 09:20 PM
Replies: 3
Views: 1,134
Posted By Dhenry

RE: Hostetler's Red Lion

Thanks PT thanks for pulling that up for me. Someday...
Forum: Kit Building
08-03-2007, 02:52 PM
Replies: 9
Views: 1,056
Posted By Dhenry

SSE servos

Ok 2 questions to you pros out there. I was thinking of a saito .82 for my SSE. To much? Would like to have plenty of power, but not have a bunch of waste. Number two which servos should I use in...
Forum: Kit Building
08-03-2007, 07:39 AM
Replies: 3
Views: 1,134
Posted By Dhenry

Hostetler's Red Lion

I'm doing some research right now on a project down the road. How are Wendell Hostetlers Plans? This might be my 3rd build if you folks think I could handle it. Built an LT -40, will be building a...
Forum: Batteries & Chargers
08-02-2007, 06:17 AM
Replies: 3
Views: 711
Posted By Dhenry

No Experience with Batteries

This is a newbie question, but I have zero experience with batteries. I just plugged the one into my LT-40 that came with my Reciever and servos. So, if I wanted to learn about batteries (electric...
Forum: Tips & Techniques
07-02-2007, 07:04 AM
Replies: 1
Views: 935
Posted By Dhenry

aircraft 3 views

What is the program (?) that I see some members using (That has 3 veiws of the aircraft.) when designing color schemes on their aircraft. Thanks idvance. Don
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-14-2007, 11:49 AM
Replies: 6
Views: 1,173
Posted By Dhenry

RE: DX7 Dim Light after Bind

Yep did that. Called and found out that I had plugged all servos in upside down (including speed controller). This caused dim light and now everything works as advertized. Thanks everyone!
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-14-2007, 06:39 AM
Replies: 6
Views: 1,173
Posted By Dhenry

RE: DX7 Dim Light after Bind

Thanks I'll be calling them this morning.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
05-13-2007, 04:12 PM
Replies: 6
Views: 1,173
Posted By Dhenry

DX7 Dim Light after Bind

After binding radio and reciever I unplug the binding jumper and then the light goes dim and no control over aircraft. Any ideas on what may be going on? Thanks in advance. Don
Forum: Beginners
05-04-2007, 08:45 AM
Replies: 4
Views: 793
Posted By Dhenry

Prop spins after radio is turned off

I have a Typhoon Electric. I recently swapped over from the original receiver and radio to a DX7 set up, but now after I turn off the xmtr radio the motor, motors the prop at a slow RPM. What is...
Forum: Giant Scale Aircraft - General
04-16-2007, 07:21 AM
Replies: 878
Views: 277,906
Posted By Dhenry

RE: Flair 1/4 Scale PT-17 Stearman Review

Where can you order one odf these kits?
Forum: Kit Building
01-27-2007, 08:55 AM
Replies: 13
Views: 3,353
Posted By Dhenry

RE: Sig LT 40 Tail wheel conversion

Hughes did you do this from plans? Is there a good picture of the tail wheel and mains out there? I was wondering where the tail wheel comes out and is mounted. Thanks all!
Forum: Kit Building
01-23-2007, 12:58 PM
Replies: 13
Views: 3,353
Posted By Dhenry

RE: Sig LT 40 Tail wheel conversion

Thanks everyone,
I will look at some other projects and thanks for the advice Knight!
Forum: Kit Building
01-20-2007, 03:40 PM
Replies: 13
Views: 3,353
Posted By Dhenry

Sig LT 40 Tail wheel conversion

Hey all,
I wanted to convert my LT 40 into a tail wheel. This being my first kit and all I'm not sure on how about to do this. I understand that mounting the mains at or just a bit in front of...
Forum: Batteries & Chargers
01-12-2007, 10:53 AM
Replies: 42
Views: 6,784
Posted By Dhenry

RE: PC Power Supply Conversion

Hi I have converted an ATX switching PS. I checked voltage accross the binding posts and it shows 13 volts, but when I hook up my parkzone charger to it, the PS shuts down. Any help would be great....
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.