RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: RCPat
Showing results 1 to 25 of 67
Search took 0.70 seconds.
Forum: Questions and Answers
12-03-2003, 12:00 PM
Replies: 9
Views: 1,123
Posted By RCPat

RE: Upside-down 4-stroke

Some 4-strokes, no matter how well you tune them, will be problematic inverted. In a case where the engine will not idle slow enough without stalling, a simple on-board glow set up will usually...
Forum: ARF or RTF
10-31-2003, 08:11 PM
Replies: 2
Views: 683
Posted By RCPat

RE: lanier extreme stik 40

DWSC:

I am halfway through the installation of my extreme stick. I decided not to use the pushrods, primarily because the plane comes out nose heavy when finished. I am going to mount 2 elevator...
Forum: Glow Engines
10-29-2003, 04:09 PM
Replies: 4
Views: 570
Posted By RCPat

RE: Transition Problem

Tom Kat:

This could be any one of many problems. However, since the engines have been run in and apparantly tweaked properly, I would venture a guess that it's probably a fuel issue.

There...
Forum: ARF or RTF
10-26-2003, 09:18 AM
Replies: 4
Views: 781
Posted By RCPat

RE: Ultra Stick 40 maiden flight today

JoeAirPort:

Very important. Examine the wing dowels after a few more flights and see if they are "burned". If so, that's a disaster waiting to happen. The ultra sticks are notorius for high...
Forum: Batteries & Chargers
10-26-2003, 09:07 AM
Replies: 4
Views: 543
Posted By RCPat

RE: Quick voltage jump

Thanks for the advice guys.

Pat
Forum: Batteries & Chargers
10-25-2003, 05:55 PM
Replies: 4
Views: 543
Posted By RCPat

Quick voltage jump

I charge my Sanyo, 600 mah batteries using the Futaba wall-wart battery charger that came with the batteries. I charge them overnight for about 14-16 hours. When I get to the field, I always check...
Forum: Questions and Answers
10-14-2003, 06:52 PM
Replies: 10
Views: 977
Posted By RCPat

RE: DEFECTIVE AVISTAR BOUGHT FROM TOWER HOBBIES

Randall:

Give Tower a call and tell them the situation. They are a great company to do business with. I'm sure they will help you if they can. In the rare circumstance that they can't help you,...
Forum: ARF or RTF
10-08-2003, 08:02 AM
Replies: 13
Views: 1,054
Posted By RCPat

RE: Sugestions for for first bipe?

2alpha:

Take a look at the Global "Ultimate". It flies like it's on a set of rails. A great first time bipe!

Good luck

Pat
Forum: The Clubhouse
10-07-2003, 06:31 PM
Replies: 24
Views: 1,280
Posted By RCPat

RE: so why do you fly

When I'm flying I forget everything else. Flying takes the stress of every day life and puts it on hold for awhile. What a concept!

You know what they say:

Even a bad day at the flying...
Forum: Beginners
10-06-2003, 06:26 PM
Replies: 9
Views: 746
Posted By RCPat

RE: Flaperons, GP Dazzler

Bakes65:

I have had a GP Dazzler for about a year. I have programmed in all sorts of wild things. Please note: The characteristics of the aircraft do NOT lend themselves to FLAPS. Even a small...
Forum: Questions and Answers
10-04-2003, 11:47 AM
Replies: 7
Views: 2,043
Posted By RCPat

RE: How do you align and drill holes for your control horns?

Catboatr:

Hangar 9 usually provides 2-56 x 3/4" or longer screws to assemble their control horns to the various surfaces. Here's what I do, and everything lines up 95% of the time.

First...
Forum: The Clubhouse
10-02-2003, 06:51 PM
Replies: 11
Views: 2,592
Posted By RCPat

RE: Long Island RC pilots

Hi Nick:

Welcome to New York. Are you sure you want to stay here? Just kidding. You are in Bellport and guess what? There's a nice flying field right in your neighborhood.

If you are...
Forum: ARF or RTF
10-01-2003, 08:06 AM
Replies: 8
Views: 958
Posted By RCPat

RE: Ultra Stick 60 rear mount Servos

To: CCRC1

That's a really NICE covering job you did on your stick. Really top notch!

Pat
Forum: ARF or RTF
09-30-2003, 06:41 PM
Replies: 8
Views: 958
Posted By RCPat

RE: Ultra Stick 60 rear mount Servos

David:

This has nothing to do with your question, but it is very important:

Just a word of advice. When you put the two indexing dowels into the leading edge of the wing for the fuselage...
Forum: ARF or RTF
09-30-2003, 06:20 PM
Replies: 92
Views: 12,158
Posted By RCPat

RE: Lanier Extreme Stick 40

Hey Salty25:

I too just got the Extreme Stick 40 from Lanier. I guess impulse buying is still alive and well on RC Universe. I saw the ad, clicked on it and got the plane in about 3 days.

...
Forum: ARF or RTF
09-27-2003, 01:37 PM
Replies: 15
Views: 1,368
Posted By RCPat

RE: ucando 60

Fossil:

Here is a link for the Iron Bay Regulator

http://www.ironbaymodelcompany.com/Webpages/Accessories/Fuel%20Regulator%20Main.html

Pat
Forum: ARF or RTF
09-26-2003, 07:11 PM
Replies: 15
Views: 1,368
Posted By RCPat

RE: ucando 60

Thanks for the input guys.

I think I'll try that regulator on for size.

Regards....................Pat:)
Forum: ARF or RTF
09-21-2003, 08:07 PM
Replies: 15
Views: 1,368
Posted By RCPat

ucando 60

I posted this question in the general forum but I'll probably get a better response here.

Has anyone had to lower the fuel tank on their ucando 60 because of the inverted engine placement? I've...
Forum: 3D Flying!
09-21-2003, 08:16 AM
Replies: 8
Views: 806
Posted By RCPat

RE: UCANDO 60 FUEL TANKS

Have any of you guys had to lower the fuel tank on the u can do 60?. I'm running an OS 91FX on the bird and fuel keeps dripping out of the carb. I always have problems with inverted engines. Any...
Forum: 3D Flying!
09-16-2003, 06:57 PM
Replies: 6
Views: 818
Posted By RCPat

RE: plane for an OS 50 SX!!!!

I have an OS 50SX on both my Ultra Stick 40 and Global Ultimate Bipe. Great engine. Lots of power.

Pat
Forum: Beginners
09-12-2003, 02:56 PM
Replies: 4
Views: 606
Posted By RCPat

RE: OS .61 FX Engine problem

Dear Ickleboggle:

Unfortunately inverted engines need some special TLC when it comes to low end. Some guys have no problems. Others, like myself, can never get the low end right. You need to...
Forum: ARF or RTF
09-11-2003, 07:05 PM
Replies: 5
Views: 698
Posted By RCPat

RE: Which ultimate?

Ed:

I have the Global Ultimate Bipe. I have an OS 50SX up front and it flies just great! Loops, rolls, inverts, verticals, just about anything you're capable of doing, the Global will do well....
Forum: Glow Engines
09-06-2003, 04:35 PM
Replies: 6
Views: 866
Posted By RCPat

muffler nipple

Thanks Mike:

I went through McMaster Carr, W.W. Grainger and a couple of others. No luck.

What I did was order 2 more Saito muffler nipples from Horizon along with 4 more nuts. I'll put two...
Forum: Glow Engines
09-04-2003, 10:17 PM
Replies: 6
Views: 866
Posted By RCPat

Saito 100

Thanks FlyingPilgrim.

I just saw the review in Model Airplane News.

The Saito's muffler nipple is metric. I'll probably never find a longer one. So I'll most likely cut it in half and braze a...
Forum: Glow Engines
09-03-2003, 11:07 PM
Replies: 6
Views: 866
Posted By RCPat

Saito 100

Would it be OK to double the length of the threaded nipple that connects to the muffler on my Saito 100? I'm building the Lancair by Great Planes and it has an enclosed cowl. Using the stock muffler...
Showing results 1 to 25 of 67
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.