RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: Weekendflyer
Showing results 1 to 25 of 41
Search took 0.64 seconds.
Forum: 3D Flying!
01-04-2016, 01:07 PM
Replies: 2
Views: 1,110
Posted By Weekendflyer

Hi, I mounted mine sideways with the muffler...

Hi, I mounted mine sideways with the muffler pointing up and off to the side. Worked out great.
Forum: Glow Engines
05-05-2011, 06:59 PM
Replies: 5
Views: 2,882
Posted By Weekendflyer

RE: Morris Power House / Rossi 60

I have several of these and they like low nitro.
Forum: Kit Building
06-01-2008, 11:57 AM
Replies: 7
Views: 1,259
Posted By Weekendflyer

RE: Moving around Kadet tailfeathers?

What did with mine was to make a tiller bar on the tail wheel and just run fishing line up to the rudder servo use a full arm and conect to the ends , which made it possible to use stock...
Forum: Gas Engines
03-24-2008, 10:45 AM
Replies: 16
Views: 2,387
Posted By Weekendflyer

RE: Converting a G-38 to electronic ignition?

Sorry I left part of the adress off http://bcmaengines.com/index.htm hope that works
Forum: Gas Engines
03-24-2008, 10:38 AM
Replies: 16
Views: 2,387
Posted By Weekendflyer

RE: Converting a G-38 to electronic ignition?

There is also BCMA Engines, http://bcmaengines.com, they have a conversion kit to its like 135.00 bucks
Forum: Giant Scale Aircraft - 3D & Aerobatic
03-18-2008, 11:03 PM
Replies: 27
Views: 2,269
Posted By Weekendflyer

RE: How do YOU seal hinges?

just flex the control surface, take a piece of monokote and fold it into a "V" and lay it in the hinge line then iron it down. If you want to make it look nice match the colors.
Forum: Quiques Aircraft Support - CLOSED
02-20-2008, 02:32 PM
Replies: 6
Views: 943
Posted By Weekendflyer

Is there a performance difference between a stock muffler or a canister?

On an 86" Yak with a DA-50, am I going to see a performance advantage between a canister or a stock muffler? Or is it just noise reduction?
Forum: ARF or RTF
12-27-2007, 07:18 PM
Replies: 12
Views: 1,498
Posted By Weekendflyer

RE: Pitts 1/3 hard to turn right

Like I said above I have alot of time on my plane and have never had this problem overall its a very responsive plane .I would keep looking
Forum: ARF or RTF
12-26-2007, 03:07 PM
Replies: 12
Views: 1,498
Posted By Weekendflyer

RE: Pitts 1/3 hard to turn right

I have been flying mine for a couple of years and have never had this problem ,I have a 50cc gas in mine
Forum: Kit Building
11-03-2007, 08:29 PM
Replies: 7
Views: 1,176
Posted By Weekendflyer

RE: Sig Kadet Midget?

I think it was called a Kadetito. RCM used to have the plans and it was just a miniture Kadet.
Forum: ARF or RTF
10-19-2007, 11:59 PM
Replies: 5
Views: 1,219
Posted By Weekendflyer

RE: GP 1/3 scale Pitts

Here is some information I found when I was putting mine together. Good luck.

http://manuals.hobbico.com/gpm/gpma1218-manual.pdf

http://www.greatplanes.com/techsupport/gpma1218tech.html
Forum: ARF or RTF
10-07-2007, 02:44 PM
Replies: 83
Views: 23,390
Posted By Weekendflyer

RE: Kadet Senior - Taildragger Conversion -Mains

I taught my son to fly with a kadet tail drager and it was powered with a four stroke 40 its now 6 years old and still a ball to fly ,I have seen them powered with everything from a 46 to a surpass...
Forum: Tips & Techniques
10-06-2007, 06:31 PM
Replies: 23
Views: 2,463
Posted By Weekendflyer

RE: Mask For CA Fumes

a friend of mine is allergic to ca and he claims that the oderless ca doesn't bother him at all, just a thought good luck
Forum: O.S. Engines Support
09-18-2007, 08:46 PM
Replies: 4
Views: 659
Posted By Weekendflyer

RE: Dose a pumped OS 91 get after run oil

Ok thanks , I have been worried about it ,I like to oil my engines but thats what I thought , I have put oil in through the crankcase breather nipple but I wont anymore , I guess running them dry...
Forum: O.S. Engines Support
08-03-2007, 06:31 AM
Replies: 4
Views: 659
Posted By Weekendflyer

Dose a pumped OS 91 get after run oil

I have a new FS-91SII-P engine. I am confused whether or not I should use after run oil , I dont want to ruin the diaphragm in the pump, I am not sure if it is like a YS or what, the instruction...
Forum: Questions and Answers
08-02-2007, 07:47 PM
Replies: 4
Views: 634
Posted By Weekendflyer

Dose a pumped OS 91 get after run oil

I have a new FS-91SII-p engine and Im confused about whether or not to us after run oil , I dont want to ruin the diaphragm in the pump, I am not sure if its like a YS or what ,the instruction manual...
Forum: ARF or RTF
06-21-2007, 09:14 PM
Replies: 83
Views: 23,390
Posted By Weekendflyer

RE: Kadet Senior - Taildragger Conversion -Mains

I converted mine to a tail dragger. All I did was add a 1/4" plate inside the bottom of the fuselage so it butts up against the forward bulk head, put a couple of pieces of triangle stock and you are...
Forum: Kit Building
04-19-2007, 05:15 PM
Replies: 4
Views: 1,048
Posted By Weekendflyer

RE: Mounting 2 aileron servos???

ya there is plenty of room ,I made rails and just mounted them flush with the wing works great , but if you want to mount them on there side that would be easy to just space the rails a little wider...
Forum: Glow Engines
04-04-2007, 06:13 PM
Replies: 18
Views: 1,336
Posted By Weekendflyer

RE: MDS nightmare

I would still back the low end needle out and blow through it ,I just went through this and it didnt clear up until I had blowen out both needles
Forum: Kit Building
03-10-2007, 04:01 PM
Replies: 13
Views: 1,644
Posted By Weekendflyer

RE: Bridi Trainer is done

I learned on one of those and it was a great plane, I think you will really like it have fun.
Forum: JR Radio & Spektrum Radios
01-14-2007, 03:10 PM
Replies: 7
Views: 833
Posted By Weekendflyer

RE: 9303 or 10x

ya like I said its a great radio I actually have been flying my Pitts on my helicopter 10X radio until I got my new one. It's just that you can't utilize all the functions.
Forum: JR Radio & Spektrum Radios
01-13-2007, 05:04 PM
Replies: 7
Views: 833
Posted By Weekendflyer

RE: 9303 or 10x

But you also have to keep in mind that with a 10X you don't have multiple flight modes (i.e. airplane, glider, heli). And for certain applications it is nice to have those. I have always liked the...
Forum: Gas Engines
11-23-2006, 09:15 AM
Replies: 10
Views: 1,237
Posted By Weekendflyer

RE: Best size Zenoah for GP 1/3 Pitts Special

For what it is worth, I have one with a 3W 50 in it. It is 19lbs ready to fly. And it flys fine. A friend of mine has a G45 in his and it flys great as well. Where I have extra power and you notice...
Forum: Gas Engines
09-10-2005, 07:20 PM
Replies: 34
Views: 3,125
Posted By Weekendflyer

RE: 3W engine customer service

When I have a problem I call Bobby at Cactus Aviation, he is hard to get a hold of but once you get him he is very promt and does everything he can to help you.
Forum: 3D Flying!
09-09-2005, 10:37 PM
Replies: 1
Views: 453
Posted By Weekendflyer

RE: Help! funtana 40 wing fitment

when I build one of the last things I do is silacone the wing sadle all you have to do is put some selafane on the wing center section, put some silacone in the wing saddle, bolt the wing on the...
Showing results 1 to 25 of 41
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.