RCU Forums - Search Results

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Community
Search
Notices
 
Search: Posts Made By: pzrwest
Showing results 1 to 25 of 500
Search took 0.59 seconds.
Replies: 1
Views: 615
Posted By pzrwest

Motor Choice

I picked up the bf109g airframe(without electronics) from Horizon Hobbies and read the reviews of the motor used in this plane, and found no one had any good words to say about it. The motor they...
05-25-2011, 06:41 AM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

As soon as the funds clear into my paypal today sometime, I will be ordering a couple 11.1v, 1300mah, 3 cell lipos
05-25-2011, 03:11 AM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

Thank you for pointing that out to me I was hopeing it was just the wrong battery.
05-24-2011, 02:30 PM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

I tried a second transmitter on the same fequency still no throttle. I then connected the lipo battery directly to the motor and it ran. Could it be because I'm useing the wrong lipo? I connected a...
05-24-2011, 11:15 AM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

Sensor Question:
On a Hobbyzone SC LP do the 2 sensors for the ACT have to be connected to the receiver for the esc section to work? The elevator and rudder servos function ok but have no throttle...
05-08-2011, 07:23 PM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

I was mistaken I ordered the wrong Lipo I should have ordered the 1300mah 3C instead of the 1300mah 2C. I guess it comes with the territory being a Noob to electric flight. Used to be a fueler. But a...
05-08-2011, 06:49 AM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

Being a noob to electric flight and Lipo batteries, I have no idea what charger to get and even how to charge a Lipo battery. I have ordered a 11.1v 2 cell Lipo for my Hobbyzone SC and looking for an...
05-07-2011, 07:46 PM
Replies: 0
Views: 971
Posted By pzrwest

Easy Wing Skins Attaching

Here is an old trick I found years ago for attaching either balsa or bristol board to foam wing cores.
1st mix some yellow carpenters glue with water in a 70(glue)-30(water)% ratio and add a few...
05-04-2011, 06:16 PM
Replies: 2
Views: 1,352
Posted By pzrwest

RE: Servo Compatibility

I received word back from hobbyzone that the servos for that rec/esc are 5 wire and regular 3 wire srevos won't work.... thank you for the reply.... Harold
05-04-2011, 04:33 AM
Replies: 11,777
Views: 2,376,126
Posted By pzrwest

RE: Official Hobby Zone

Can one use Futaba type mini servos with this esc/receiver ESC/Receiver CH 1: SC LP HobbyZone HBZ7351 or must you only use Mini Servo (5W) with Arms, Short Lead ParkZone PKZ1070 servos with the...
05-04-2011, 04:29 AM
Replies: 2
Views: 1,352
Posted By pzrwest

Servo Compatibility

Can one use Futaba type mini servos with this esc/receiver ESC/Receiver CH 1: SC LP HobbyZone HBZ7351 or must you only use Mini Servo (5W) with Arms, Short Lead ParkZone PKZ1070 servos with the...
Forum: Sport Flying
05-03-2011, 05:59 PM
Replies: 0
Views: 485
Posted By pzrwest

Servo Compatability

moved to electric flight section
Forum: RC Tanks
05-02-2011, 09:18 PM
Replies: 10
Views: 1,834
Posted By pzrwest

RE: Firefly from a converted Viper Sherman

I'm not sure where Geoff got them. One of out club members painted his with thinned Tamy paint in the correct color...it came out very nice hid the camo very well
Forum: RC Tanks
05-02-2011, 04:55 AM
Replies: 10
Views: 1,834
Posted By pzrwest

RE: Firefly from a converted Viper Sherman

Here are some pics of the Firefly taken by Geoff after he got home. Also the recce turretless Stuart is finished and is in the pics. As always comments are welcomed.... Harold
...
Forum: RC Tanks
04-22-2011, 06:17 AM
Replies: 10
Views: 1,834
Posted By pzrwest

RE: Firefly from a converted Viper Sherman

The viper shermans would be a major chore to rc being all resin. The transmission section of the hull is almost one solid piece and the sprocket axels are in place when the section was cast, and...
Forum: RC Tanks
04-21-2011, 07:56 PM
Replies: 10
Views: 1,834
Posted By pzrwest

Firefly from a converted Viper Sherman

Here are a few pics of a Sherman Firefly that I converted from a Viper Sherman. Good friend and fellow member of the Ottawa One Sixth Club Geoff(Johnny Canuck) asked me to convert two of his viper...
Forum: RC Tanks
03-29-2011, 07:46 AM
Replies: 18
Views: 2,492
Posted By pzrwest

RE: The 1/6th Tanks Are Comming

Update:
The construction crew have been hard at work on the firefly. Here are the next series of pics.
Here are the air filters assembled and installed. They are held in place with a screw on...
Forum: RC Tanks
03-22-2011, 08:14 PM
Replies: 16
Views: 3,212
Posted By pzrwest

RE: My 1/6th Sherman

Thank you Chris
Forum: RC Tanks
03-19-2011, 04:45 PM
Replies: 16
Views: 3,212
Posted By pzrwest

RE: My 1/6th Sherman

RC Vantex / Fuyuan has a new rc M4A3 Sherman out in both gas or electric. Armorguy(John) from East Coast Armory is doing a detail session on it on SAG here's the link. ...
Forum: RC Tanks
03-19-2011, 12:51 PM
Replies: 16
Views: 3,212
Posted By pzrwest

RE: My 1/6th Sherman

No it's static but Jack may want to rc it down the road which can be easily done.
Forum: RC Tanks
03-19-2011, 09:41 AM
Replies: 16
Views: 3,212
Posted By pzrwest

RE: My 1/6th Sherman

Well she's finally finished and before took her home I took some pics of her outside with natural light. It turned out quite nice for an el-cheapo Sherman. Main thing is Jack likes it and that's all...
Forum: RC Tanks
02-13-2011, 05:40 PM
Replies: 15
Views: 1,488
Posted By pzrwest

RE: Resistors to stop tank jerking?

You would think that after all the remarks reguarding the tank jerk when firing the gun sound HL etc would remove it from their chips
Forum: RC Tanks
02-03-2011, 06:59 PM
Replies: 18
Views: 2,492
Posted By pzrwest

RE: The 1/6th Tanks Are Comming

With the viper sherman's it would be very hard to rc since the ends of the transmission houseings are almost solid resin, would take alot of grinding to remove alot of the resin. There is a gas and...
Forum: RC Tanks
02-03-2011, 01:09 PM
Replies: 18
Views: 2,492
Posted By pzrwest

RE: The 1/6th Tanks Are Comming

Update:
Well work continues. Been awhile since the last post. Here are a few new pics. I added the armored bow gun cover plate and the add on armor plates infront of the driver and co-driver...
Forum: RC Tanks
01-22-2011, 08:52 PM
Replies: 92
Views: 7,380
Posted By pzrwest

RE: poor traction issue, suggestions please!

Another one confuseing tanks with dune buggies. Like was said probably bottoming out the hull and tracks just spin.
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.