RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: nitrofirebug
Showing results 1 to 25 of 64
Search took 0.36 seconds.
Forum: RC Nitro Stadium Trucks
09-05-2008, 07:15 PM
Replies: 11
Views: 1,265
Posted By nitrofirebug

RE: RC10GT2

My FT RC10GT2 would wheelie with the .15 from a standing start, I stopped it from doing that by putting my throttle EPA down to 73% from 125% ;)

I think $200 is not bad if in good condition...
Forum: RC Nitro Stadium Trucks
06-29-2008, 12:34 PM
Replies: 93
Views: 4,414
Posted By nitrofirebug

RE: Your suggestions for a decent 2wd ST please

I would go for the GT2 or XXXNT, everything else is just a toy :D

http://youtube.com/watch?v=GkbVUaYtMVg

http://youtube.com/watch?v=VJR6iDrnBSA

Some good GT2 bashing videos to go with...
Forum: RC Car General Discussions
03-11-2008, 01:54 PM
Replies: 324
Views: 34,995
Posted By nitrofirebug

RE: Official track-building thread

Some action shot :)
Forum: RC Car General Discussions
03-11-2008, 01:50 PM
Replies: 324
Views: 34,995
Posted By nitrofirebug

RE: Official track-building thread

A link to my dirt tracks thread :)
http://www.rcuniverse.com/forum/m_6818940/mpage_1/key_/tm.htm

Videos of the track, dont laugh I had my lil bro beat... I mean drive my RC10GT2 for the video....
Forum: RC Nitro Stadium Trucks
01-28-2008, 01:37 PM
Replies: 21
Views: 1,144
Posted By nitrofirebug

RE: Best All Out Racer Kit?

The only two racers for the stadium truck class are the RC10GT2 factory team kit and the XXX-NT AD2 kit, because of how they are built and there durability, plus they are set up roar legal, you pick...
Forum: RC Nitro Stadium Trucks
01-06-2008, 04:11 PM
Replies: 7
Views: 626
Posted By nitrofirebug

RE: CB installation

Clutch bell

Does your os have an SG shaft? If so it will work fine if not you'll need to cut it to make it work. I have not done this but have heard about it. I do have an os 18 cvr with a cut...
Forum: RC Nitro Stadium Trucks
01-06-2008, 01:07 PM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

Thank you! :D

Don’t tell me about rocks, I hate rocks [>:] I know that’s a strong feeling for a rock, but I cant help it, I hate'em! [:@]

I had allot of rocks as well, but a whole lot...
Forum: RC Nitro Stadium Trucks
01-06-2008, 12:51 PM
Replies: 7
Views: 1,788
Posted By nitrofirebug

RE: rc10gt carb ?

Sounds like the idle screw is working [8D] try loosening the little screw with the spring a little bit, not all the way. it should close, but you want it open 1mm to start off.
Forum: RC Nitro Stadium Trucks
01-04-2008, 11:44 AM
Replies: 3
Views: 549
Posted By nitrofirebug

RE: Purpose of a 3rd Channel ?

I totally agree [8D] if you go racing, it really sucks using the transponders the track passes out, allot of the times they are not fully charged so your laps dont get counted, now that sucks. Pay...
Forum: RC Nitro Stadium Trucks
01-04-2008, 11:32 AM
Replies: 11
Views: 746
Posted By nitrofirebug

RE: Upgrade transmitter?

I like my Airtronics MX-3 FHSS 2.4 GHz and you can get them for less than $200
Forum: RC Nitro Stadium Trucks
01-03-2008, 02:36 PM
Replies: 29
Views: 4,204
Posted By nitrofirebug

RE: Best .12/.15 engine for a little racing and speed runs/ jumping......

http://www.teamtrinity.com/shop/item.asp?item=TRI40008

more info
Forum: RC Nitro Stadium Trucks
01-03-2008, 02:29 PM
Replies: 29
Views: 4,204
Posted By nitrofirebug

RE: Best .12/.15 engine for a little racing and speed runs/ jumping......

Not cheap but you asked ;) I think these might be close [8D]

http://h1071118.hobbyshopnow.com/products/description.asp?prod=TRI40009

http://www.modelflight.com.au/sirio_engines.htm

...
Forum: RC Nitro Stadium Trucks
01-03-2008, 12:43 PM
Replies: 29
Views: 4,204
Posted By nitrofirebug

RE: Best .12/.15 engine for a little racing and speed runs/ jumping......

Nevermind just saw it doesnt have and SG crank, but I here you can cut it, if you want :eek:

I have the OS 12 TR R-spec with turbo head for my GT2, when my new bump box comes,I'll tell ya if I...
Forum: RC Nitro Stadium Trucks
01-03-2008, 12:39 PM
Replies: 29
Views: 4,204
Posted By nitrofirebug

RE: Best .12/.15 engine for a little racing and speed runs/ jumping......

Here ya go [8D]


http://cgi.ebay.com/Trinity-Picco-P12-12-Racing-Engine-Part-TP095-NIB_W0QQitemZ320202589064QQihZ011QQcategoryZ34062QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
Forum: RC Nitro Stadium Trucks
01-03-2008, 11:50 AM
Replies: 6
Views: 841
Posted By nitrofirebug

RE: i hate picco

How did you find out you have an air leak coming from the starter shaft? Just curious.
Forum: RC Nitro Stadium Trucks
01-03-2008, 11:47 AM
Replies: 9
Views: 613
Posted By nitrofirebug

RE: finally!!!

you'll want a 6.0v hump pack
Forum: RC Nitro Stadium Trucks
01-03-2008, 11:45 AM
Replies: 9
Views: 778
Posted By nitrofirebug

RE: Graphite VS. Aluminum for replacement parts

If you want to upgrade your XXX-NT I would get the graphite parts from the AD2 kit, the metal brace from the AD2 kit, and the quick change rear wheel setup from the AD2 kit.

Other than that,...
Forum: RC Nitro Stadium Trucks
12-31-2007, 01:25 PM
Replies: 1
Views: 757
Posted By nitrofirebug

RE: Slide Carb on GT2 & Engine ?'s

Same setup just the throttle linkage will be where the return spring is and the brake on the opposite side and reverse the throttle servo, that’s how I saw it done, losi says to put the servo in...
Forum: RC Nitro Stadium Trucks
12-31-2007, 12:55 PM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

I think SouthFloridaAppraiser was playin around and not being serious but thats just me jumping to conclusions :D hahaha sorry I had to :eek:

My dog stays outta the way! It doesnt matter who or...
Forum: RC Nitro Stadium Trucks
12-31-2007, 11:07 AM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

All day every day!!!!!!!!! Woohoo!!!!! :D

I really was thinking about lights [X(] I was trying to figure out what would be the most cost efficient lights to use. Any suggestions?
Forum: RC Nitro Stadium Trucks
12-31-2007, 11:03 AM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

Hey thats a really cool track, I like how you set it up so you have to jump over part of the track.

My brother, girlfriend, and I all worked together to make this track, I wanted it so we could...
Forum: RC Nitro Stadium Trucks
12-31-2007, 10:51 AM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

Right now I have my throttle EPA at 65% out of 125% and I still pull small wheelies, wouldnt that just make it worse?

electric hahaha yeah thats a good one! :D then it wouldnt sound like a F1...
Forum: RC Nitro Stadium Trucks
12-29-2007, 01:52 PM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

The tightest corner on the track is 5 ft. The big jump in the small straight-away is a 7 ft gap, from takeoff to landing. I remeasured the track and it is 70ft X 40ft.

We run about 7 tanks a...
Forum: RC Nitro Stadium Trucks
12-28-2007, 11:34 PM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

I lived in Palm Desert for 14 years, I didnt drive rc's then though, didnt have much of a yard back then [&o] Off Cook St. and Merle Dr. [8D] Allot of ATV tracks though ;)

Thank you for posting...
Forum: RC Nitro Stadium Trucks
12-28-2007, 11:15 PM
Replies: 27
Views: 2,516
Posted By nitrofirebug

RE: My backyard track!

another vidieo of the same but more laps :D again dont laugh its my lil bro driving, when the car crashes I just think wow what a strong rc :D The GT2 can take a beating over and over, it doesnt seem...
Showing results 1 to 25 of 64
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.