RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: York
Showing results 1 to 25 of 25
Search took 0.71 seconds.
Forum: 3D Flying!
08-30-2003, 06:43 PM
Replies: 0
Views: 528
Posted By York

Favorite 3D video/DVD?

Something without pattern flying--just incredible freestyle 3D.
Forum: Futaba Radios Direct support forum
08-30-2003, 06:17 PM
Replies: 17
Views: 1,769
Posted By York

9C powered by lithium

How long is your 1800mAh lasting?
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-30-2003, 04:59 PM
Replies: 24
Views: 1,662
Posted By York

source for 'rubber ducky' antennae?

Thanks for the info. You do understand, however, that you and I pay for our specific frequencies as well.
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-30-2003, 02:25 PM
Replies: 24
Views: 1,662
Posted By York

source for 'rubber ducky' antennae?

We pay for our frequencies--it's called Federal Income Tax!!! Evidently you weren't aware of that?

Also--who has registered use of the 20 hertz "between" each of our channels? I wasn't aware of...
Forum: Futaba Radios Direct support forum
08-30-2003, 11:06 AM
Replies: 17
Views: 1,769
Posted By York

Evolution

I understand that NiCd and NiMH work flawlessly in the 9C.

Lithium chemistry, however, could offer several times the capacity of the best NiMH. Or a much lighter radio at the same battery...
Forum: RC Radios, Transmitters, Receivers, Servos, gyros
08-29-2003, 06:28 PM
Replies: 6
Views: 710
Posted By York

Radio Channel

I'm a paid user via my Federal income tax.
Forum: Futaba Radios Direct support forum
08-23-2003, 01:52 AM
Replies: 17
Views: 1,769
Posted By York

9C powered by lithium

The nominal load voltage on Li cells is 3.7V--not 4.2V so the 3 cell pack voltage under load would be 11.1V. I understand the 9C puts quite a load on the batteries so the depressed voltage value...
Forum: Futaba Radios Direct support forum
08-17-2003, 09:18 PM
Replies: 17
Views: 1,769
Posted By York

9C powered by lithium

I use lithium packs in my Multiplex Cockpit everyday. The standard Multiplex pack is a 7.2V NiCad/NiMH so it's not a big jump to go with a 2 cell lithium pack at a nominal voltage of 7.4V.
...
Forum: RC Warbirds and Warplanes
03-19-2003, 07:33 PM
Replies: 198
Views: 34,922
Posted By York

Need Advice on Ziroli Stuka

GRAHAM--HOW'S YOUR STUKA GOING?
Forum: RC Warbirds and Warplanes
03-19-2003, 06:42 PM
Replies: 72
Views: 8,621
Posted By York

Construction Begins!!!!!!!!!!!!

Joe--thanks for the link. I have seen your wonderful website. My question, when I referred to your finished scale aircraft, was directed at models you have finished in the past. I was curious if you...
Forum: RC Warbirds and Warplanes
03-18-2003, 10:20 PM
Replies: 72
Views: 8,621
Posted By York

Construction Begins!!!!!!!!!!!!

Congratulations on the scale event invite and a beautiful Hurricane in progress!

Is there a link on your website to pictures of your finished scale aircraft? If not could you post a few here--I'm...
Forum: RC Warbirds and Warplanes
01-26-2003, 06:44 PM
Replies: 1,056
Views: 211,857
Posted By York

Show every one what your P-51 mustangs look like, A Thread worth seeing,Awsome planes

Dago Red, I appreciate your enthusiam regarding these 'stangs. Perhaps you could pace your comments to every 20 posts instead of every 3-5? I have this vision of you being punished in grade school...
Forum: Aerodynamics
12-30-2002, 07:48 PM
Replies: 24
Views: 3,683
Posted By York

High Quality (and Cheap) Airfoil Program!

Thanks Wild Blue! Worked like a charm--why didn't I think of that?
Forum: Extreme Speed Prop Planes
12-23-2002, 09:10 PM
Replies: 6
Views: 793
Posted By York

Fast airfoil for a Delta

Murrat, is your figure of 45 degrees sweep from the 25% chord lines (as by convention) or from the LE?
Forum: Scratch Building, Aircraft Design, 3D/CAD
12-23-2002, 09:01 PM
Replies: 5
Views: 759
Posted By York

Profili programme

I've found the above features in Compufoil but not Profili, has your experience been different?
Forum: Aerodynamics
12-23-2002, 05:23 PM
Replies: 24
Views: 3,683
Posted By York

Foam Templates

Does Profili allow you to consruct the foam templates for the upper and lower airfoil surfaces? While playing around with my registered version I've only had success with the upper surface.
Forum: Aerodynamics
12-22-2002, 06:43 PM
Replies: 73
Views: 6,031
Posted By York

flat spin problems, what is causing this death spin.

WR, the Hoerner wing tip is not downturned.

The Agwagon has A-10 style downturned wing tips.
Forum: Aerodynamics
11-24-2002, 02:17 AM
Replies: 68
Views: 5,514
Posted By York

Why So Many CG Questions?

Ollie, I hope that you are not losing sleep over this. With any hobby there is a spectrum of experience and involvement. There was even a point in time when you did not know where the COG was. You...
Forum: Composites Fabrication And Repair
11-24-2002, 01:46 AM
Replies: 17
Views: 2,277
Posted By York

Cloth fact and fiction

OK, I found this in an OSHA report:

Toxicological Information:
Graphite causes benign pneumoconiosis (graphitosis). Symptoms of pneumoconiosis from graphite exposure are dypsnea, coughing, black...
Forum: Composites Fabrication And Repair
11-24-2002, 12:55 AM
Replies: 17
Views: 2,277
Posted By York

Cloth fact and fiction

Is CF really bad for you?

I've looked in several toxicology texts and have not found it. I know of no pulmonary disorders associated with CF. Are there only anecdotal reports or has someone done...
Forum: RC Warbirds and Warplanes
10-24-2002, 02:54 PM
Replies: 2
Views: 1,083
Posted By York

Ziroli Stuka--G-62 alternatives

Thanks Bill. It seems that so many folks go to extreme effort to create a realistic warbird only to shatter that with nonscale protrusions--when scale options are easily available. I'm happy to see...
Forum: RC Warbirds and Warplanes
10-24-2002, 02:16 PM
Replies: 66
Views: 19,013
Posted By York

Brian Taylor Me 109 E 68"

Ham639--I've considered the BT 109 kit. SOunds like you've made good progress. Do you think you could post some pics of the plane before you sheet it?
Forum: RC Warbirds and Warplanes
10-24-2002, 11:56 AM
Replies: 602
Views: 99,369
Posted By York

Building a Ziroli B-25(CONDENSED VERSION)

You project photos and narrative have been inspiring--thanks for the effort. I look forward to a flight report when your B-25 takes to the air. Keep us posted!
Forum: RC Warbirds and Warplanes
10-23-2002, 06:04 PM
Replies: 2
Views: 1,083
Posted By York

Ziroli Stuka--G-62 alternatives

Does anyone have EXPERIENCE with an engine that fits completely in the cowl.

Thanks.
Forum: Composites Fabrication And Repair
10-23-2002, 02:39 PM
Replies: 7
Views: 1,355
Posted By York

Cowling

If making a cowl using fiberglass over foam, instead of digging out the foam couldn't you use gasoline to melt it out? (Being certain that is wouldn't affect your resin).

I remember hearing of...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.